Search results
Results From The WOW.Com Content Network
The Internet Engineering Task Force (IETF) has reserved the IPv4 address block 169.254.0.0 / 16 (169.254.0.0 – 169.254.255.255) for link-local addressing. [1] The entire range may be used for this purpose, except for the first 256 and last 256 addresses (169.254.0.0 / 24 and 169.254.255.0 / 24), which are reserved for future use and must not be selected by a host using this dynamic ...
Common uses for ifconfig include setting the IP address and subnet mask of a network interface and disabling or enabling an interface. [1] At boot time, many Unix-like operating systems initialize their network interfaces with shell scripts that call ifconfig. As an interactive tool, system administrators routinely use the utility to display ...
A broadcast address is a network address used to transmit to all devices connected to a multiple-access communications network. A message sent to a broadcast address may be received by all network-attached hosts. In contrast, a multicast address is used to address a specific group of devices, and a unicast address is used to address a single ...
In Linux distributions based on 2.2.x Linux kernels, the ifconfig and route commands are operated together to connect a computer to a network, and to define routes between computer networks. Distributions based on later kernels have deprecated ifconfig and route, replacing them with iproute2. Route for Linux was originally written by Fred N ...
The Address Resolution Protocol (ARP) is a communication protocol for discovering the link layer address, such as a MAC address, associated with a internet layer address, typically an IPv4 address. The protocol, part of the Internet protocol suite , was defined in 1982 by RFC 826 , which is Internet Standard STD 37.
A public IP address is a globally routable unicast IP address, meaning that the address is not an address reserved for use in private networks, such as those reserved by RFC 1918, or the various IPv6 address formats of local scope or site-local scope, for example for link-local addressing. Public IP addresses may be used for communication ...
Then, the command ipconfig /renew is executed to request a new IP address. [ 3 ] [ 4 ] Where a computer is connected to a cable or DSL modem, it may have to be plugged directly into the modem network port to bypass the router, before using ipconfig /release and turning off the power for a period of time, to ensure that the old IP address is ...
The original list of IPv4 address blocks was published in September 1981. [3] In previous versions of the document, [19] [20] network numbers were 8-bit numbers rather than the 32-bit numbers used in IPv4. At that time, three networks were added that were not listed earlier: 42.rrr.rrr.rrr, 43.rrr.rrr.rrr, and 44.rrr.rrr.rrr.