Ads
related to: trapped end fed long wire antennas for ham radio mobile antenna reviews
Search results
Results From The WOW.Com Content Network
Often random wire antennas are also (inaccurately) referred to as long-wire antennas.There is no accepted minimum size, but actual long-wire antennas must be greater than at least a quarter-wavelength ( 1 / 4 λ) or perhaps greater than a half ( 1 / 2 λ) at the frequency the long wire antenna is used for, and even a half-wave may only be considered "long-ish" rather than "truly ...
A 20-meter-long T²FD antenna, covering the 5-30 MHz band. The T ilted T erminated F olded D ipole ( T²FD , T2FD , or TTFD ) or B alanced T ermination, F olded D ipole ( BTFD ) - also known as W3HH antenna - is a general-purpose shortwave antenna developed in the late 1940s by the United States Navy .
A dipole can be fed from very near its end (needing to be only about 1 / 20 th of the dipole length from the actual end) but the end impedances are exceedingly high – a few thousands of ohms, depending on the average height of the antenna and thickness of its wire. The end location has an inconveniently high impedance, but it is ...
A transmatch (antenna tuner) is not required to use this antenna near its nominal design frequency of 14 MHz, and judicious length adjustments can sometimes include one other frequency band. All other frequencies require a transmatch. [citation needed] There are many variants of the G5RV antenna. Two variations of the G5RV design, called ZS6BKW ...
The angle of the slope is usually between 45°–60° and the lower end of the wire is at least 1 ⁄ 6 wavelength above the electrical ground. [3] A sloper is typically fed with a coaxial cable in the center, at the top of the center support mast. At least 1 ⁄ 4 of the wavelength of feedline must be at 90° angle to the antenna. [3]
The J-pole antenna is an end-fed omnidirectional half-wave antenna that is matched to the feedline by a shorted quarter-wave parallel transmission line stub. [5] [1] [6] For a transmitting antenna to operate efficiently, absorbing all the power provided by its feedline, the antenna must be impedance matched to the line; it must have a resistance equal to the feedline's characteristic impedance.