Ads
related to: fluke pressure calibrators low pressure meter
Search results
Results From The WOW.Com Content Network
A dead weight tester (DWT) is a calibration standard method that uses a piston cylinder on which a load is placed to make an equilibrium with an applied pressure underneath the piston. Deadweight testers are secondary standards which means that the pressure measured by a deadweight tester is defined through other quantities: length, mass and ...
Fluke Corporation is an American manufacturer of industrial test, measurement, and diagnostic equipment, including electronic test equipment. It was started in 1948 by John Fluke while he was employed at General Electric .
Automatic calibration - A U.S. serviceman using a 3666C auto pressure calibrator. An automatic pressure calibrator [13] is a device that combines an electronic control unit, a pressure intensifier used to compress a gas such as Nitrogen, a pressure transducer used to detect desired levels in a hydraulic accumulator, and accessories such as ...
Example of the widely used Bourdon pressure gauge Checking tire pressure with a spring and piston tire-pressure gauge. Pressure measurement is the measurement of an applied force by a fluid (liquid or gas) on a surface. Pressure is typically measured in units of force per unit of surface area.
A McLeod gauge is a scientific instrument used to measure very low pressures, down to 10 −6 Torr (0.133 mPa). It was invented in 1874 by Herbert McLeod (1841–1923). [ 1 ] McLeod gauges were once commonly found attached to equipment that operates under vacuum , such as a lyophilizer .
The thermal conductivity and heat capacity of the gas affects the readout from the meter, and therefore the apparatus may need calibrating before accurate readings are obtainable. For lower pressure measurement, the thermal conductivity of the gas becomes increasingly smaller and more difficult to measure accurately, and other instruments such ...
Ads
related to: fluke pressure calibrators low pressure meter