Search results
Results From The WOW.Com Content Network
Focal length (f) refers to the elevation difference between the film and the lens. [2] [4] H is the elevation difference between the lens and the sea level, which is the average level of the water surface. [2] [4] h is the elevation difference between the terrain surface and the sea level. [2] [4] S is the scale of aerial photographs.
The complete unit is normally mounted on a tripod, and the telescope can freely rotate 360° in a horizontal plane.The surveyor adjusts the instrument's level by coarse adjustment of the tripod legs and fine adjustment using three precision levelling screws on the instrument to make the rotational plane horizontal.
Benchmark (surveying) – fixed reference point of known elevation with respect to which RL of other points is determined. Benchmarks can be arbitrary or permanent, the former is used for calculation of reduced levels for small survey works and the latter is used to calculate the elevations of significantly important locations and points.
There may be obstructions or large changes of elevation between the endpoints. In these situations, extra setups are needed. Turning is a term used when referring to moving the level to take an elevation shot from a different location. To "turn" the level, one must first take a reading and record the elevation of the point the rod is located on.
An Ordnance Survey cut mark in the UK Occasionally a non-vertical face, and a slightly different mark, was used. The term benchmark, bench mark, or survey benchmark originates from the chiseled horizontal marks that surveyors made in stone structures, into which an angle iron could be placed to form a "bench" for a leveling rod, thus ensuring that a leveling rod could be accurately ...
Altimetry is the measurement of altitude or elevation above sea level. Common techniques are: [8] [9] Surveying, especially levelling. Global Navigation Satellite System (such as GPS), where a receiver determines a location from pseudoranges to multiple satellites. A geoid is needed to convert the 3D position to sea-level elevation.
A Philadelphia rod is a level staff used in surveying. The rod is used in levelling procedures to determine elevations and is read using a level. A Philadelphia rod consists of two sliding sections graduated in hundredths of a foot. On the front of the rod the graduation increasing from zero at the bottom.
This can be calculated for a given peak in the following manner: for every path connecting the peak to higher terrain, find the lowest point on the path; the key col (or highest saddle, or linking col, or link) is defined as the highest of these points, along all connecting paths; the prominence is the difference between the elevation of the ...