Ads
related to: waterproofing membrane for concrete slab
Search results
Results From The WOW.Com Content Network
Concrete normally allows moisture to pass through so a vertical vapor barrier is needed. Barriers may be a coating or membrane applied to the exterior of the concrete. The coating may be asphalt, asphalt emulsion, a thinned asphalt called cutback asphalt, or an elastomer. [9] Membranes are rubberized asphalt or EPDM rubber. Rubberized products ...
Masonry walls are built with a damp-proof course to prevent rising damp, and the concrete in foundations needs to be damp-proofed or waterproofed with a liquid coating, basement waterproofing membrane (even under the concrete slab floor where polyethylene sheeting is commonly used), or an additive to the concrete.
Waterproofing an existing basement begins with excavating to the bottom sides of the footings. Once excavated, the walls are then power washed and allowed to dry. The dry walls are sealed with a waterproofing membrane, [3] and new drainage tiles (weeping tiles) are placed at the side of the footing.
A Formosan termite and waterproofing barrier installed on a foundation in Greenville, SC. Applications for termite membranes include on concrete foundation walls, ICF insulated concrete forms, under-slab waterproofing, under-sill plates, flooring underlayments, and as wall, window, and door flashings, among others. Most termite membranes must ...
A slab-on-grade or basement floor should be poured over a cross-laminated polyethylene vapor barrier over 4 inches (10 cm) of granular fill to prevent wicking of moisture from the ground and radon gas incursion. Inside a steel building, water vapor will condense whenever it comes into contact with a surface that is below the dew point temperature.
When creating hydrophobic concrete through a coating process, a coating is sprayed or brushed onto a porous surfaces. In most cases, it is applied to a regular concrete slab that then undergoes a corrosive process to expose more of the concrete's capillaries. This can be achieved by water blasting the surface at about 3,000-4,000 psi.