Ads
related to: fast blow fuse identification
Search results
Results From The WOW.Com Content Network
The fastest blowing fuses are designed for the most sensitive electrical equipment, where even a short exposure to an overload current could be damaging. Normal fast-blow fuses are the most general purpose fuses. A time-delay fuse (also known as an anti-surge or slow-blow fuse) is designed to allow a current which is above the rated value of ...
A 130 volt, 150 J MOV that has undergone catastrophic failure, apparently as a result of a lightning strike, showing evidence of heat and smoke. The 3 amp fast-blow fuse immediately in front of the varistor blew during the same event. A series connected thermal fuse is one solution to catastrophic MOV failure.
The fuses listed are the most common for the size, which is always a fast-acting fuse: 1AG size, type AGA, 1 A to 30 A, 1 ⁄ 4 inch (6.4 mm) diameter by 5 ⁄ 8 inch (15.9mm) long [ 10 ] 2AG size, type AGB, 0.177 in (4.5 mm) diameter by 0.588 in (14.9 mm) long (frequently replaced with 5mm diameter by 15mm long international size fuse (aka 5 x ...
Because standard safety fuse burns at around half a metre per minute, it is not practicable to provide delays of more than a few minutes in this way. It was also possible to connect a pencil detonator to so-called "instantaneous fuse" (not to be confused with detonating cord) which had an unusually fast burn rate of over 7 metres per second.
In electrical engineering, IEC 60269 is a set of technical standards for low-voltage power fuses. [1] The standard is in four volumes, which describe general requirements, fuses for industrial and commercial applications, fuses for residential applications, and fuses to protect semiconductor devices.
In computing, an eFuse (electronic fuse) is a microscopic fuse put into a computer chip. This technology was invented by IBM in 2004 [ 1 ] to allow for the dynamic real-time reprogramming of chips. In the abstract, computer logic is generally "etched" or "hard-wired" onto a chip and cannot be changed after the chip has finished being manufactured.
The fuse element, or "fuse link", is the replaceable portion of the assembly that melts and breaks the circuit when the electric current through it exceeds its rated current value. There are many types of fuse elements for many different uses such as a type T fuse also known as a "slow-blow fuse" being used for sidelines.
A version of this simple fuse is called visco fuse, and consists of the burning core coated with wax or lacquer for durability and water resistance. Early fuses for grenades also consist of a wooden plug with a longitudinal hole filled with a slow burning gunpowder mixture inserted into the grenade. Such fuses were in use until the 18th century ...