Ads
related to: pulse pressure calculator mdapp water pump replacement guide
Search results
Results From The WOW.Com Content Network
Pulse pressure is calculated as the difference between the systolic blood pressure and the diastolic blood pressure. [3] [4]The systemic pulse pressure is approximately proportional to stroke volume, or the amount of blood ejected from the left ventricle during systole (pump action) and inversely proportional to the compliance (similar to elasticity) of the aorta.
The alternating pressure build up and escape causes a pulsing effect, hence the name: pulser pump. The maximum air pressure that can accumulate depends on the height of the water column between the air chamber and the lower reservoir. The deeper the air chamber is positioned, the higher the elevation to which the water can be pumped.
These pumps employ rollers to squeeze the tube. Except for a 360° eccentric pump design, these pumps have a minimum of 2 rollers 180° apart and may have as many as 8, or even 12 rollers. Increasing the number of rollers increases the pressure pulse frequency of the pumped fluid at the outlet, thereby decreasing the amplitude of pulsing.
Thermodynamic pump testing is a form of pump testing where only the temperature rise, power consumed, and differential pressure need to be measured to find the efficiency of a pump. These measurements are typically made with insertion temperature probes and pressure probes fitted to tapping points on the pump's inlet and outlet. [ 1 ]
In medicine, the mean arterial pressure (MAP) is an average calculated blood pressure in an individual during a single cardiac cycle. [1] Although methods of estimating MAP vary, a common calculation is to take one-third of the pulse pressure (the difference between the systolic and diastolic pressures), and add that amount to the diastolic pressure.
Although metering pumps can pump water, they are often used to pump chemicals, solutions, or other liquids. Many metering pumps are rated to be able to pump into a high discharge pressure. They are typically made to meter at flow rates which are practically constant (when averaged over time) within a wide range of discharge (outlet) pressure.