Ad
related to: how to avoid damp spots on drywall walls pictures
Search results
Results From The WOW.Com Content Network
Excess moisture causes paint to lose its adhesion, pull away from the drywall, and create uneven air pockets. That's why bubbling paint is most commonly seen in kitchens and bathrooms , where ...
A DPC layer is usually laid below all masonry walls, regardless if the wall is a load bearing wall or a partition wall. A damp-proof membrane (DPM) is a membrane material applied to prevent moisture transmission. A common example is polyethylene sheeting laid under a concrete slab to prevent the concrete from gaining moisture through capillary ...
A slab-on-grade or basement floor should be poured over a cross-laminated polyethylene vapor barrier over 4 inches (10 cm) of granular fill to prevent wicking of moisture from the ground and radon gas incursion. Inside a steel building, water vapor will condense whenever it comes into contact with a surface that is below the dew point temperature.
An example of a damp proof course of slate in a brick wall intended to prevent rising damp. A physical damp proof course made from plastic can be installed into an existing building by cutting into short sections of the mortar course, and installing short sections of the damp proof course material.
S. lacrymans is a form of brown rot, a group of fungi which digest the cellulose and hemicellulose in timber. This particular species poses the greatest threat to buildings since it can spread through non-nutrient providing materials (e.g., masonry and plaster) for several meters until it finds more timber to attack.
Masonry walls are built with a damp-proof course to prevent rising damp, and the concrete in foundations needs to be damp-proofed or waterproofed with a liquid coating, basement waterproofing membrane (even under the concrete slab floor where polyethylene sheeting is commonly used), or an additive to the concrete.
For premium support please call: 800-290-4726 more ways to reach us
Sometimes fine sand is used to backfill but more often insulation boards are laid against it before backfilling, particularly in an inhabited room. As a further precaution against water ingress, it is recommended that land drains be installed behind the protected wall at its base to prevent the buildup of hydrostatic pressure in wet weather.