Search results
Results From The WOW.Com Content Network
Often when considering rotating shafts, only the first natural frequency is needed. There are two main methods used to calculate critical speed—the Rayleigh–Ritz method and Dunkerley's method. Both calculate an approximation of the first natural frequency of vibration, which is assumed to be nearly equal to the critical speed of rotation.
Dunkerley's method [1] [2] is used in mechanical engineering to determine the critical speed of a shaft-rotor system. Other methods include the Rayleigh–Ritz method . Whirling of a shaft
Analysis shows that there are well-damped critical speed at lower speed range. Another critical speed at mode 4 is observed at 7810 rpm (130 Hz) in dangerous vicinity of nominal shaft speed, but it has 30% damping - enough to safely ignore it. Analytically computed values of eigenfrequencies as a function of the shaft's rotation speed. This ...
These take the form of a pair of balance shafts that rotate in opposite directions at twice engine speed, known as Lanchester shafts, after the original manufacturer. In V8 engines , the problem is usually avoided by using a cross-plane crankshaft , and a 180° or single-plane crankshaft is used only in high-performance V8 engines, where it ...
The critical speed of a rotating machine occurs when the rotational speed matches its natural frequency. The lowest speed at which the natural frequency is first encountered is called the first critical speed, but as the speed increases, additional critical speeds are seen which are the multiples of the natural frequency.
The running speed for a leadscrew (or ball screw) is typically limited to, at most, 80% of the calculated critical speed. The critical speed is the speed that excites the natural frequency of the screw. For a steel leadscrew or steel ballscrew, the critical speed is approximately [18] = where = critical speed in RPM
Cutting speed may be defined as the rate at the workpiece surface, irrespective of the machining operation used. A cutting speed for mild steel of 100 ft/min is the same whether it is the speed of the cutter passing over the workpiece, such as in a turning operation, or the speed of the cutter moving past a workpiece, such as in a milling operation.
The critical load is the greatest load that will not cause lateral deflection (buckling). For loads greater than the critical load, the column will deflect laterally. The critical load puts the column in a state of unstable equilibrium. A load beyond the critical load causes the column to fail by buckling. As the load is increased beyond the ...