Ad
related to: segmentation with paging diagram
Search results
Results From The WOW.Com Content Network
In a system using segmentation, computer memory addresses consist of a segment id and an offset within the segment. [3] A hardware memory management unit (MMU) is responsible for translating the segment and offset into a physical address, and for performing checks to make sure the translation can be done and that the reference to that segment and offset is permitted.
If the paging unit is enabled, addresses in a segment are now virtual addresses, rather than physical addresses as they were on the 80286. That is, the segment starting address, the offset, and the final 32-bit address the segmentation unit derived by adding the two are all virtual (or logical) addresses when the paging unit is enabled.
The 80286 added an MMU that supports segmentation, but not paging. When segmentation is enabled by turning on protected mode, the segment number acts as an index into a table of segment descriptors; a segment descriptor contains a base physical address, a segment length, a presence bit to indicate whether the segment is currently in memory ...
Overlays are not a method of paging RAM to disk but merely of minimizing the program's RAM use. Subsequent architectures used memory segmentation, and individual program segments became the units exchanged between disk and RAM. A segment was the program's entire code segment or data segment, or sometimes other large data structures.
Illegal accesses and invalid page faults can result in a segmentation fault or bus error, resulting in an app or OS crash. Software bugs are often the causes of these problems, but hardware memory errors, such as those caused by overclocking, may corrupt pointers and cause valid code to fail.
Paging allows the CPU to map any page of the virtual memory space to any page of the physical memory space. To do this, it uses additional mapping tables in memory called page tables. Protected mode on the 80386 can operate with paging either enabled or disabled; the segmentation mechanism is always active and generates virtual addresses that ...
This will typically occur because of a programming error, and the operating system must take some action to deal with the problem. On modern operating systems, it will cause a segmentation fault signal being sent to the offending program. The lookup may also fail if the page is currently not resident in physical memory.
The x86 and x86-64 segment descriptor has the following form: [3] Where the fields stand for: Base Address Starting memory address of the segment. Its length is 32 bits and it is created from the lower part bits 16 to 31, and the upper part bits 0 to 7, followed by bits 24 to 31.