Search results
Results From The WOW.Com Content Network
A punch down tool, punchdown tool, IDC tool, or a Krone tool (named after the Krone LSA-PLUS connector), is a small hand tool used by telecommunication and network technicians. It is used for inserting wire into insulation-displacement connectors on punch down blocks , patch panels , keystone modules , and surface mount boxes (also known as ...
Compression connectors on an isolating valve; the reddish part is a copper compression ring Compression fittings (sometimes called "lock-bush fittings") consist of a tapered, concave conical seat; a hollow, barrel-shaped compression ring (sometimes called a ferrule); and a compression nut which is threaded onto the body of the fitting and ...
Rear release contacts are released and removed from the rear (wire side) of the connector. The removal tool releases the contacts from the rear and pulls the contact out of the retainer. Crimp connections are used typically to attach RF connectors, such as BNC connectors, to coaxial cables [20] quickly, as an alternative to soldered connections ...
The reinforcement in a RC structure, such as a steel bar, has to undergo the same strain or deformation as the surrounding concrete in order to prevent discontinuity, slip or separation of the two materials under load. Maintaining composite action requires transfer of load between the concrete and steel.
The name is derived from fish, [1] a wooden reinforcement of a "built-up" ship's mast that helped round out its desired profile. [2] The top and bottom faces taper inwards along their short dimensions to create an even alignment between the two rails when the fish plate is wedged into place by tightening its bolts during installation.
BS 4482: Steel wire for the reinforcement of concrete products. Specification (2005) BS 4483: Steel fabric for the reinforcement of concrete. Specification (2005) BS 6744: Stainless steel bars for the reinforcement of and use in concrete. Requirements and test methods. (2001/2009) DIN 488-1: Reinforcing steels - Part 1: Grades, properties ...
Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.
The MIL-spec choke flanges have a gap width of between 2% and 3% of the waveguide height (the smaller inner dimension of the guide), which for WR28 waveguide (WG22) amounts to a gap of just 3 thousandths of an inch. The choke ditch in these flanges is some 8 times wider (around 20% of the waveguide height), although the proportions vary ...