Search results
Results From The WOW.Com Content Network
Ethernet over USB is the use of a USB link as a part of an Ethernet network, resulting in an Ethernet connection over USB (instead of e.g. PCI or PCIe).. USB over Ethernet (also called USB over Network or USB over IP) is a system to share USB-based devices over Ethernet, Wi-Fi, or the Internet, allowing access to devices over a network.
hostapd (host access point daemon) is a user space daemon software enabling a network interface card to act as an access point and authentication server. There are three implementations: Jouni Malinen's hostapd, OpenBSD's hostapd and Devicescape's hostapd.
A network service access point address (NSAP address), defined in ISO/IEC 8348, is an identifying label for a service access point (SAP) used in OSI networking.. These are roughly comparable to IP addresses used in the Internet Protocol; they can specify a piece of equipment connected to an Asynchronous Transfer Mode (ATM) network.
A network tap is a system that monitors events on a local network. A tap is typically a dedicated hardware device, which provides a way to access the data flowing across a computer network. The network tap has (at least) three ports: an A port, a B port, and a monitor port. A tap inserted between A and B passes all traffic (send and receive ...
In this diagram the router is a single point of failure for the communication network between computers. A single point of failure (SPOF) is a part of a system that would stop the entire system from working if it were to fail. [1] The term single point of failure implies that there is not a backup or redundant option that would enable the ...
Service access points are also used in IEEE 802.2 Logical Link Control in Ethernet and similar data link layer protocols. When using the OSI Network system (CONS or CLNS), the base for constructing an address for a network element is an NSAP address, similar in concept to an IP address.
Both in-band and out-of-band management are usually done through a network connection, but an out-of-band management card can use a physically separated network connector if preferred. A remote management card usually has at least a partially independent power supply and can switch the main machine on and off through the network.
The WLAN controller automatically handles the configuration of wireless access-points. It centralizes wireless network infrastructure and handles bandwidth allocation to the access points (APs). Before the use of WLCs were widespread, APs had to handle connections individually, leading to unstable data links and poor connections.