Ads
related to: line splice welding
Search results
Results From The WOW.Com Content Network
Subsequently, the fibers are fused together (welded) with an electric arc. Since no additional material is added, such as gas welding or soldering, this is called a "fusion splice". Depending on the quality of the splicing process, attenuation values at the splice points are achieved by 0.3 dB, with good splices also below 0.02 dB.
Figure parts A–D show steps in forming a "short tie" Western Union splice. Figure parts E and F show two possible "long tie" variations. [2]The Western Union splice or lineman splice is a method of joining electrical cable, developed in the nineteenth century during the introduction of the telegraph and named for the Western Union telegraph company.
A tube-shaped connector with two crimps for splicing wires in-line is called a butt splice connector. Single-wire crimp terminals include: Blade or quick disconnect (e.g., Faston or Lucar) Bullet (e.g. Shur-Plug) Butt splice; Flag tongue; Rectangular tongue; Hook tongue; Spade tongue (flanged, short spring, long spring) Ring tongue (slotted ...
The location of the elements of a welding symbol when following US conventions. In the US, the component elements of the weld specification are: [2] The reference line - the body of the arrow which is the baseline for the specification. The arrow tip which goes at an angle to the reference line, pointing to the joint to be welded.
A cut splice is a join between two ropes, made by side splicing the ends slightly apart, to make an eye in the joined rope which lies shut when the rope is taut. Its original name was bowdlerised to "cut splice". A line eye-spliced to a snap shackle; Eye splice – A splice where the working end is spliced into the working part forming a loop.
Side view of a beam with two weld access holes cut into the web. Also the flanges have been beveled in preparation for welding. The weld access hole or rat hole is a structural engineering technique in which a part of the web of an I-beam or T-beam is cut out at the end or ends of the beam.