Search results
Results From The WOW.Com Content Network
The coilover combines a shock absorber and a spring in a single unit. A common form of automotive suspension strut in an automobile is the MacPherson strut. MacPherson struts are often purchased by the automakers in sets of four completed sub-assemblies: These can be mounted on the car bodies as part of the manufacturers' own assembly operations.
Unlike a shock absorber, a strut has a reinforced body and stem. Struts are subjected to multidirectional loads, while a shock absorber only damps vibration, only receiving a load along its axis. Struts and shock absorbers have a different way of attachment. Shock absorbers are mounted through rubber or urethane bushings to the frame and ...
The strut will usually carry both the coil spring, on which the body is suspended, and the shock absorber, which is usually in the form of a cartridge mounted within the strut (see coilover). The strut can also have the steering arm built into the lower outer portion. The whole assembly is very simple and can be pre-assembled into a unit.
Oleo strut - design used in most large aircraft, with compressed gas and hydraulic fluid - conceptually similar to automobile Hydropneumatic suspension; Scrub radius; Short long arms suspension — also known as "unequal length A arm", one of the design parameters of double wishbone suspension; Strut bar — a part to make a suspension setup ...
The shock absorber and coil spring mount to the wishbones to control vertical movement. Double wishbone designs allow the engineer to carefully control the motion of the wheel throughout suspension travel, controlling such parameters as camber angle , caster angle , toe pattern, roll center height, scrub radius , scuff ( mechanical abrasion ...
A strut bar, strut brace, or strut tower brace (STB) is an automotive suspension accessory on a monocoque or unibody chassis to provide extra stiffness between the strut towers. With a MacPherson strut suspension system where the spring and shock absorber combine in one suspension unit, which also replaces the upper control arm, the entire ...
The connection between the hub carrier and the shock absorber base was made rigid, making the spring unit into a strut and also controlling the camber angle. Using the drive shaft itself to control the rear track meant that the shaft could be of fixed length, avoiding the need for a sliding spline joint and its stiction problems.
The MacPherson strut is a common form of strut suspension. This was not the first attempt at strut suspension, but in MacPherson's original patent, the anti-roll bar forms an integral and essential part of the suspension, in addition to its usual function in controlling body roll. A strut suspension like MacPherson's requires a hinged lower ...