Search results
Results From The WOW.Com Content Network
Often random wire antennas are also (inaccurately) referred to as long-wire antennas.There is no accepted minimum size, but actual long-wire antennas must be greater than at least a quarter-wavelength ( 1 / 4 λ) or perhaps greater than a half ( 1 / 2 λ) at the frequency the long wire antenna is used for, and even a half-wave may only be considered "long-ish" rather than "truly ...
The rhombic antenna is a directional wire antenna used on MF and HF bands for shortwave reception. The antenna consists of a wire suspended above the ground in the shape of a rhombus , terminated at one end by a resistor equal the the wire's characteristic impedance, about 400 to 600 ohms, and at the other end connected to the feedline to the ...
A rhombic antenna is made of four sections of wire suspended parallel to the ground in a diamond or "rhombus" shape. Each of the four sides is the same length – about a quarter-wavelength to one wavelength per section – converging but not touching at an angle of about 42° at the fed end and at the far end.
An automotive wiring diagram, showing useful information such as crimp connection locations and wire colors. These details may not be so easily found on a more schematic drawing. A wiring diagram is a simplified conventional pictorial representation of an electrical circuit. It shows the components of the circuit as simplified shapes, and the ...
A transmatch (antenna tuner) is not required to use this antenna near its nominal design frequency of 14 MHz, and judicious length adjustments can sometimes include one other frequency band. All other frequencies require a transmatch. [citation needed] There are many variants of the G5RV antenna. Two variations of the G5RV design, called ZS6BKW ...
Moxon antenna for the 20-meter band.The antenna is the faint rectangle of wires held in tension by the bent X-shaped support frame. Moxon antenna for the 2-meter band. The Moxon antenna or Moxon rectangle is a simple and mechanically rugged two-element parasitic array, single-frequency antenna. [1]
The trideco antenna is a huge specialized umbrella antenna used in a few high power military transmitters at very low frequency (VLF). [ 5 ] [ 6 ] In a conventional umbrella antenna, the use of the sloping guy wires as the capacitive top load has some disadvantages: First, since the umbrella wires must be anchored to the ground, their length is ...
The angle of the slope is usually between 45°–60° and the lower end of the wire is at least 1 ⁄ 6 wavelength above the electrical ground. [3] A sloper is typically fed with a coaxial cable in the center, at the top of the center support mast. At least 1 ⁄ 4 of the wavelength of feedline must be at 90° angle to the antenna. [3]