Search results
Results From The WOW.Com Content Network
In October 2008, Apple announced that it would be using LED backlights for all of its notebooks and new 24-inch Apple Cinema Display, and one year later it introduced a new LED iMac, meaning all of Apple's new computer screens became LED-backlit displays. Almost every laptop with a 16:9 display introduced since September 2009 uses LED-backlit ...
The following table compares cathode-ray tube (CRT), liquid-crystal display (LCD), plasma and organic light-emitting diode (OLED) display device technologies. These are the most often used technologies for television and computer displays.
TV, computer monitor: Yes Monochrome CRT: Spherical curve or flat 30 [3] 76 TV, computer monitor, radar display, oscilloscope: Yes Direct view Charactron CRT: Spherical curve 24 61 Computer monitor, radar display: No CRT self-contained rear-projection Flat lenticular: 80 [4] 203 TV: Yes CRT front projection: Flat (limited only by brightness) TV ...
frame dimming: adjusts the brightness of the entire backlight based on the content displayed, as if local dimming was supported but only with a single zone; local dimming: multiple vertical or horizontal zones are individually controlled; direct-lit (DLED) or full-array: LEDs form an array directly behind the screen at equally spaced intervals.
Luminance is used in the video industry to characterize the brightness of displays. A typical computer display emits between 50 and 300 cd/m 2. The sun has a luminance of about 1.6 × 10 9 cd/m 2 at noon. [3] Luminance is invariant in geometric optics. [4]
Depending on the set display brightness and content being displayed, the older CCFT backlit models typically use less than half of the power a CRT monitor of the same size viewing area would use, and the modern LED backlit models typically use 10–25% of the power a CRT monitor would use.
As a measure of light emitted per unit area, this unit is frequently used to specify the brightness of a display device. The sRGB spec for monitors targets 80 cd/m 2. [3] Typically, monitors calibrated for SDR broadcast or studio color grading should have a brightness of 100 cd/m 2. [4]
A good monitor with proper calibration shows the six numbers on the right in both bars, a cheap monitor shows only four numbers. Given a desired display-system gamma, if the observer sees the same brightness in the checkered part and in the homogeneous part of every colored area, then the gamma correction is approximately correct.