When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Cooling load temperature difference calculation method

   en.wikipedia.org/wiki/Cooling_load_temperature...

   The first of the cooling load factors used in this method is the CLTD, or the Cooling Load Temperature Difference. This factor is used to represent the temperature difference between indoor and outdoor air with the inclusion of the heating effects of solar radiation. [1] [5] The second factor is the CLF, or the cooling load factor.

3. Cooling load - Wikipedia

   en.wikipedia.org/wiki/Cooling_load

   The cooling load [3] is calculated to select HVAC equipment that has the appropriate cooling capacity to remove heat from the zone. A zone is typically defined as an area with similar heat gains, similar temperature and humidity control requirements, or an enclosed space within a building with the purpose to monitor and control the zone's temperature and humidity with a single sensor e.g ...

4. Sol-air temperature - Wikipedia

   en.wikipedia.org/wiki/Sol-air_temperature

   The above equation only takes into account the temperature differences and ignores two important parameters, being 1) solar radiative flux; and 2) infrared exchanges from the sky. The concept of T sol-air was thus introduced to enable these parameters to be included within an improved calculation. The following formula results:

5. Coefficient of performance - Wikipedia

   en.wikipedia.org/wiki/Coefficient_of_performance

   The coefficient of performance or COP (sometimes CP or CoP) of a heat pump, refrigerator or air conditioning system is a ratio of useful heating or cooling provided to work (energy) required. [1] [2] Higher COPs equate to higher efficiency, lower energy (power) consumption and thus lower operating costs. The COP is used in thermodynamics.

6. CFD in buildings - Wikipedia

   en.wikipedia.org/wiki/CFD_in_buildings

   External and internal environment of buildings: wind loading, ventilation analysis and heating/cooling load calculations. Previously, most building-related issues such as ventilation analysis, wind loading, wind environment etc. were examined using wind tunnel tests, but today all these tests can be done effectively with CFD.

7. Underfloor air distribution - Wikipedia

   en.wikipedia.org/wiki/Underfloor_air_distribution

   Cooling load profiles for UFAD systems and overhead systems are different, [12] mainly due to the thermal storage effect of the lighter-weight raised floor panels compared to the heavier mass of a structural floor slab. The mere presence of the raised floor reduces the ability of the slab to store heat, thereby producing for the system with a ...