Ad
related to: outboard reed valve symptoms and causes pdf list
Search results
Results From The WOW.Com Content Network
The reed valve is a simple but highly effective form of check valve commonly fitted in the intake tract of the piston-controlled port. It allows asymmetric intake of the fuel charge, improving power and economy, while widening the power band. Such valves are widely used in motorcycle, ATV, and marine outboard engines.
A stroke is the action of a piston travelling the full length of its cylinder.In a two-stroke engine, one of the two strokes combines primarily the intake stroke and the combustion stroke, while the other stroke primarily combines the compression stroke and the exhaust stroke, though technically since both ports are exposed during both the combustion and compression strokes, some reversion ...
A pair of Malossi reed valve blades made from carbon fibre. Reed valves are commonly used in high-performance versions of the two-stroke engine, where they control the fuel-air mixture admitted to the cylinder. As the piston rises in the cylinder a vacuum is created in the crankcase beneath the piston. The resulting pressure differential opens ...
Leaf valves are commonly mounted in the intake port of most 2-stroke motorcycle engines. When the piston moves up in the cylinder, the valve opens and allows air and fuel to pass through the intake port and into the carburetor. When the piston moves down, the valve closes and the compressed air in the cylinder is forced out through the exhaust ...
Small boats with outboard engines and personal water crafts (PWC) tend to ingest water simply because they run in and around it. During a rollover, or when a wave washes over the craft, its engine can hydrolock, though severe damage is rare due to the special air intakes and low rotating inertia of small marine engines.
This motor was based on previous models KE-7 Lightning and KF-7 Super 10 Lightning. Upgrades included redesigned connecting rods, upgraded aluminum clamp and swivel brackets, a new higher RPM magneto, improved porting, an 8 Reed valve cage (as opposed to KE-7 and KF-7's 4) and larger crankcase opening.
Excessive hammer blow from high slipping speeds was a cause of kinked rails with new North American 4–6–4s and 4–8–4s that followed the 1934 A.A.R. recommendation to balance 40% of the reciprocating weight. [8] Out-of-balance inertia forces in the wheel can cause different vertical oscillations depending on the track stiffness.
The first known outboard motor was a small 11 pound (5 kg) electric unit designed around 1870 by Gustave Trouvé, [9] and patented in May 1880 (Patent N° 136,560). [10] Later about 25 petrol powered outboards may have been produced in 1896 by American Motors Co [9] —but neither of these two pioneering efforts appear to have had much impact.