Search results
Results From The WOW.Com Content Network
The steering pivot points [clarification needed] are joined by a rigid bar called the tie rod, which can also be part of the steering mechanism, in the form of a rack and pinion for instance. With perfect Ackermann, at any angle of steering, the centre point of all of the circles traced by all wheels will lie at a common point.
Illustration of a ring-and-pinion differential for a rear-wheel drive vehicle Schematic diagram of a ring-and pinion differential. A relatively simple design of differential is used in rear-wheel drive vehicles, whereby a ring gear is driven by a pinion gear connected to the transmission.
A rack and pinion has roughly the same purpose as a worm gear with a rack replacing the gear, in that both convert torque to linear force. However the rack and pinion generally provides higher linear speed — since a full turn of the pinion displaces the rack by an amount equal to the pinion's pitch circle whereas a full rotation of the worm screw only displaces the rack by one tooth width.
Also, the pinion can be designed with fewer teeth than a spiral bevel pinion, with the result that gear ratios of 60:1 and higher are feasible using a single set of hypoid gears. [37] This style of gear is most common in motor vehicle drive trains, in concert with a differential. Whereas a regular (nonhypoid) ring-and-pinion gear set is ...
In many cases, such as remote controlled toys, the pinion is also the drive gear for a reduction in speed, since electric motors operate at higher speed and lower torque than desirable at the wheels. However the reverse is true in watches, where gear trains commence with a high-torque, low-speed spring and terminate in the fast-and-weak escapement.
In hypoid gear design, the pinion and gear are practically always of opposite hand, and the spiral angle of the pinion is usually larger than that of the gear. The hypoid pinion is then larger in diameter than an equivalent bevel pinion. A hypoid gear incorporates some sliding and can be considered halfway between a straight-cut gear and a worm ...
If S is an integral extension of a commutative ring R, then S and R have the same dimension. Closely related concepts are those of depth and global dimension. In general, if R is a noetherian local ring, then the depth of R is less than or equal to the dimension of R. When the equality holds, R is called a Cohen–Macaulay ring.
Starter ring gear attached to a flywheel. In cars with a manual transmission, the starter ring gear is fitted to the outer diameter of the flywheel.The ring gear is usually fixed to the flywheel through use of an interference fit, [2] which is achieved by heating the ring gear and so that thermal expansion allows it to be placed around the flywheel.