Search results
Results From The WOW.Com Content Network
Unlike air brakes, where a valve is opened and air flows into the lines and brake chambers until the pressure rises sufficiently, hydraulic systems rely on a single stroke of a piston to force fluid through the system. If any vapor is introduced into the system it will compress, and the pressure may not rise sufficiently to actuate the brakes.
Banjo fittings are commonly found in automotive fuel, [2] motor oil and hydraulic systems (e.g.: brakes and clutch). General applications include: Hydraulic power systems; Power steering fluid; Variable valve timing systems; Brake caliper connectors [1] Turbo charger oil feeds; Fuel filter connectors [3] Carburetor connector [2] Hydraulic ...
The most common vehicle uses of master cylinders are in brake and clutch systems.. In brake systems, the operated devices are cylinders inside brake calipers and/or drum brakes; these cylinders may be called wheel cylinders or slave cylinders, and they push the brake pads towards a surface that rotates with the wheel (this surface is typically either a drum or a disc, a.k.a. a rotor) until the ...
A cross-section of a proportioning safety valve. A proportioning valve is a valve that relies on the laws of fluid pressure to distribute input forces to one or more output lines. Proportioning valves are frequently used in cars and other road vehicles to reduce the brake fluid pressure to the rear brakes. Due to weight distribution during ...
The pressure of the rear wheels are approximated to the ideal brake force distribution in a partial braking operation. To do so, the conventional brake design is modified in the direction of rear axle overbraking, and the components of the ABS are used. EBD reduces the strain on the hydraulic brake force proportioning valve in the vehicle.
Winch brake circuit: a shuttle valve provides brake control in pneumatic winch applications. When the compressor is operated the shuttle valves direct air to open the brake shoes. When the control valve is centered, the brake cylinder is vented through the shuttle valve, and the brake shoes are allowed to close. [clarification needed]
A servo valve receives pressurized hydraulic fluid from a source, typically a hydraulic pump. It then transfers the fluid to a hydraulic cylinder in a closely controlled manner. Typically, the valve will move the spool proportionnaly to an electrical signal that it receives, indirectly controlling flow rate.
An autobrake is a type of automatic wheel-based hydraulic brake system for advanced airplanes. [1] The autobrake is normally enabled during takeoff and landing procedures, when the aircraft's longitudinal deceleration system can be handled by the automated systems of the aircraft itself in order to keep the pilot free to perform other tasks.