Ad
related to: us nautical mile chart
Search results
Results From The WOW.Com Content Network
A nautical mile is a unit of length used in air, marine, and space navigation, and for the definition of territorial waters. [2] [3] [4] Historically, it was defined as the meridian arc length corresponding to one minute ( 1 / 60 of a degree) of latitude at the equator, so that Earth's polar circumference is very near to 21,600 nautical miles (that is 60 minutes × 360 degrees).
The Office of Coast Survey is responsible for preparing and maintaining over a thousand nautical charts covering the exclusive economic zone off the coast of the United States and its territories, extending 200 nautical miles (370 km; 230 mi) offshore and covering a total area of 3,400,000 square nautical miles (12,000,000 km 2; 4,500,000 sq mi ...
A 1976 United States NOAA chart of part of Puerto Rico A nautical chart of the Warnemünde harbor shown on OpenSeaMap. A nautical chart or hydrographic chart is a graphic representation of a sea region or water body and adjacent coasts or banks.
[89] In the United States, the nautical mile was defined in the 19th century as 6,080.2 feet (1,853.24 m), whereas in the United Kingdom, the Admiralty nautical mile was defined as 6,080 feet (1,853.18 m) and was about one minute of latitude in the latitudes of the south of the UK. Other nations had different definitions of the nautical mile.
Nautical mile: Length: Rhumb: Angle: The angle between two successive points of the thirty-two point compass (11 degrees 15 minutes) (rare) [1] Shackle: Length: Before 1949, 12.5 fathoms; later 15 fathoms. [2] Toise: Length: Toise was also used for measures of area and volume Twenty-foot equivalent unit or TEU: Volume: Used in connection with ...
The data for method 1 was retrieved from a CRS Report for Congress [1] using data from U.S. Department of Commerce, National Oceanic and Atmospheric Administration, The Coastline of the United States, 1975. [2] This is based on measurements made using large-scale nautical charts. The figure for Connecticut was arrived at separately and may not ...
Normally, the baseline is the low-water line along the coast as marked on large-scale charts that the coastal state recognizes. This is either the low-water mark closest to the shore or an unlimited distance from permanently exposed land, provided that some portion of elevations exposed at low tide but covered at high tide (such as mud flats) is within 3 nautical miles (5.6 kilometres; 3 + 1 ...
The main units of length (inch, foot, yard and international mile) were the same in the US, though the US rarely uses some of the intermediate units today, such as the (surveyor's) chain (22 yards) and the furlong (220 yards). At one time, the definition of the nautical mile was based on the surface area of the Clarke ellipsoid.