When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Air lock - Wikipedia

   en.wikipedia.org/wiki/Air_lock

   Depending on the pipe layout – if there are any upside down 'U's in the circuit – it will be necessary to vent the highest point(s). Otherwise, air lock may cause waterfall flow where the loss of hydraulic head is equal to the height of airlock; If the hydraulic grade line drops below the output of the pipe, the flow through that part of ...

3. Air gap (plumbing) - Wikipedia

   en.wikipedia.org/wiki/Air_gap_(plumbing)

   This "air gap" is visible above the sink as a small cylindrical fixture mounted near the faucet. In the base cabinet under the sink, the drain hose from the dishwasher feeds the "top" of the air gap, and the "bottom" of the air gap is plumbed into the sink drain below the basket, or into a garbage disposal unit. When installed and maintained ...

4. Drain-waste-vent system - Wikipedia

   en.wikipedia.org/wiki/Drain-waste-vent_system

   A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.

5. Trap (plumbing) - Wikipedia

   en.wikipedia.org/wiki/Trap_(plumbing)

   The U-bend could not jam, so, unlike the S-bend, it did not need an overflow. In the United States, traps are commonly referred to as P-traps. It is the addition of a 90 degree fitting on the outlet side of a U-bend, thereby creating a P-like shape (oriented horizontally). It is also referred to as a sink trap because it is installed under most ...

6. Automatic balancing valve - Wikipedia

   en.wikipedia.org/wiki/Automatic_balancing_valve

   Since most air-conditioning and water distribution systems only reach peak load for limited periods, energy is wasted by continually running the pumps at a fixed speed. In variable-flow hydronic systems, reducing pump speed or staging of pumps with boilers and chillers to suit part-load conditions is an energy efficient method of control.

7. Invert level - Wikipedia

   en.wikipedia.org/wiki/Invert_level

   A pipe laser, or another vertical distance measuring device is most commonly used for this. Invert levels are important for the drainage of a non-pressured fluid pipe. Typically, a good design requires that the invert level of the pipe will be lower (or at least not higher) for each section of pipe before it reaches its final destination. [5]