Search results
Results From The WOW.Com Content Network
Consider a Yagi–Uda consisting of a reflector, driven element, and a single director as shown here. The driven element is typically a 1 ⁄ 2 λ dipole or folded dipole and is the only member of the structure that is directly excited (electrically connected to the feedline). All the other elements are considered parasitic. That is, they ...
A folded dipole is, technically, a folded full-wave loop antenna, where the loop has been bent at opposing ends and squashed into two parallel wires in a flat line. Although the broad bandwidth, high feedpoint impedance, and high efficiency are characteristics more similar to a full loop antenna, the folded dipole's radiation pattern is more ...
Adding a director to this, to give a 3 element Yagi, gives a gain of about 7 dB over a dipole. As a rule of thumb, each additional parasitic element beyond this adds about 1 dB of gain. [2] In an example of a parasitic element that is not rod-shaped, a parasitic microstrip patch antenna is sometimes mounted above another driven patch antenna ...
It is a two element Yagi-Uda antenna with folded dipole elements, and no director(s). Because of the folded ends, the element lengths are approximately 70% of the equivalent dipole length. The two-element design gives modest directivity (about 2.0 dB ) with a null towards the rear of the antenna, yielding a high front-to-back ratio : Gain up to ...
Corner reflector UHF TV antenna from 1954 with bowtie dipole driven element. A corner reflector antenna is a type of directional antenna used at VHF and UHF frequencies. [1] [2] It was invented by John D. Kraus in 1938. [3] [4] It consists of a dipole driven element mounted in front of two flat rectangular reflecting screens joined at an angle ...
It is easier to design a multiband quad antenna than a multiband Yagi antenna. Higher gain The 2-element quad has almost the same gain as a 3-element Yagi: about 7.5 dB over a dipole. Likewise, a 3-element quad has more gain than a 3-element Yagi. However, adding quad elements produces diminishing returns:
A turnstile antenna, or crossed-dipole antenna, [1] is a radio antenna consisting of a set of two identical dipole antennas mounted at right angles to each other and fed in phase quadrature; the two currents applied to the dipoles are 90° out of phase. [2] [3] The name reflects the notion the antenna looks like a turnstile when mounted ...
A Vivaldi antenna or Vivaldi aerial [1] or tapered slot antenna [2] is a co-planar broadband-antenna, which can be made from a solid piece of sheet metal, a printed circuit board, or from a dielectric plate metalized on one or both sides.