Ads
related to: jeep yj 4.2 vs 4.0 transmission panstreetsmarttransmission.com has been visited by 10K+ users in the past month
Search results
Results From The WOW.Com Content Network
The "big hole" (4" input) Dana 18 is transmission-interchangeable with the Dana 20. Almost all Dana 18 and Dana 20 input gears are 6-spline; the only exception is the one used with the 10-spline version of the T14 transmission. Some International Scout Dana 20s with a 727 automatic transmission use a 23 spline 26 tooth gear
1991 Jeep Renegade. From October 1990 until 1994, Jeep produced an options package on the YJ Wrangler listed as the "Renegade Decor Group". Vehicles were shipped as optioned Wranglers to Autostyle in the Detroit area, where the Renegade Decor Package was installed, then shipped back to Jeep for delivery to dealers. Renegades all have a small ...
The AX15 built by Aisin was used in Jeeps with the AMC 242 (4.0L) Inline 6 engine, as well as the AMC 258 (4.2L) Inline 6 engine and AMC (2.5L) Straight 4 engine.This included vehicles such as the Cherokee(XJ), Comanche (MJ), and Wrangler (YJ and TJ) and 1994-1995 Jeep Grand Cherokee ZJ as well as the 1st and 2nd generations of the Dodge Dakota.
Jeep CJ; Jeep Wagoneer/Grand Wagoneer; Kaiser Jeep was purchased by AMC in 1970. The Buick 350 cu in (5.7 L) V8, AMC 232 I6, and AMC 327, 360 V8 engines in the FSJ Wagoneer and trucks used a 'nailhead' pattern TH400—also known as a "unipattern," as it was used by many other manufacturers (including Rolls-Royce and Jaguar) with an adapter ring—from 1965 to 1972.
The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars. A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick ...
The 'N' mode disengages the transfer case, transmission, and engine from the axles, thus enabling flat-towing the Jeep behind another vehicle. In 1983, the NP219-based Quadra-Trac system was replaced by the NP228/229-based Selec-Trac , adding a fuel-saving 2WD mode to the full- and part-time 4WD modes of Quadra-Trac.