Search results
Results From The WOW.Com Content Network
1.80 [16] 1.26: battery, Fluoride-ion [citation needed] 1.7: 2.8: battery, Hydrogen closed cycle H fuel cell [17] 1.62: Hydrazine decomposition (as monopropellant) 1.6: 1.6: Ammonium nitrate decomposition (as monopropellant) 1.4: 2.5: Thermal Energy Capacity of Molten Salt: 1 [citation needed] 98% [18] Molecular spring approximate [citation ...
A moderate energy density would be 1.6 to 3 calories per gram (7–13 kJ/g); salmon, lean meat, and bread would fall in this category. Foods with high energy density have more than three calories per gram (>13 kJ/g) and include crackers, cheese, chocolate, nuts, [10] and fried foods like potato or tortilla chips.
Specific absorption rate (SAR) is a measure of the rate at which energy is absorbed per unit mass by a human body when exposed to a radio frequency (RF) electromagnetic field. It is defined as the power absorbed per mass of tissue and has units of watts per kilogram (W/kg). [1]
The ancient Greek understanding of physics was limited to the statics of simple machines (the balance of forces), and did not include dynamics or the concept of work. During the Renaissance the dynamics of the Mechanical Powers, as the simple machines were called, began to be studied from the standpoint of how far they could lift a load, in addition to the force they could apply, leading ...
These tables list values of molar ionization energies, measured in kJ⋅mol −1. This is the energy per mole necessary to remove electrons from gaseous atoms or atomic ions. The first molar ionization energy applies to the neutral atoms.
The strength of a bond can be estimated by comparing the atomic radii of the atoms that form the bond to the length of bond itself. For example, the atomic radius of boron is estimated at 85 pm, [10] while the length of the B–B bond in B 2 Cl 4 is 175 pm. [11] Dividing the length of this bond by the sum of each boron atom's radius gives a ratio of
According to the International Atomic Energy Agency for a 3,000 MW (t) PWR the normal coolant radioactivity levels are shown below in the table, and the coolant activities for reactors which have been allowed to dry out (and over heat) before being recovered with water. In a gap release the activity in the fuel/cladding gap has been released ...
A good example is ultraviolet spectrum energy which begins at about 3.1 eV (400 nm) at close to the same energy level which can cause sunburn to unprotected skin, as a result of photoreactions in collagen and (in the UV-B range) also damage in DNA (for example, pyrimidine dimers). Thus, the mid and lower ultraviolet electromagnetic spectrum is ...