When.com Web Search

  1. Ads

    related to: u drain with starter bar for refrigerator bottom water dispenser pump

Search results

  1. Results From The WOW.Com Content Network
  2. Uniform Plumbing Code - Wikipedia

    en.wikipedia.org/wiki/Uniform_Plumbing_Code

    Designated as an American National Standard, the Uniform Plumbing Code (UPC) is a model code developed by the International Association of Plumbing and Mechanical Officials to govern the installation and inspection of plumbing systems as a means of promoting the public's health, safety and welfare.

  3. Trap (plumbing) - Wikipedia

    en.wikipedia.org/wiki/Trap_(plumbing)

    In domestic applications, traps are typically U, S, Q, or J-shaped pipe located below or within a plumbing fixture.An S-shaped trap is also known as an S-bend.It was invented by Alexander Cumming in 1775 but became known as the U-bend following the introduction of the U-shaped trap by Thomas Crapper in 1880.

  4. Water dispenser - Wikipedia

    en.wikipedia.org/wiki/Water_dispenser

    Bottled water dispensers can be top-mounted or bottom-loaded, depending on the design of the model. Bottled water dispensers typically use 11- or 22-liter (5- or 10-gallon) dispensers commonly found on top of the unit. Pressure coolers are a subcategory of water dispensers encompassing drinking water fountains and direct-piping water dispensers ...

  5. Fixture unit - Wikipedia

    en.wikipedia.org/wiki/Fixture_unit

    A Fixture Unit is not a flow rate unit but a design factor. A fixture unit is equal to 1 cubic foot (0.028 m 3) of water drained in a 1 + 1 ⁄ 4 inches (32 mm) diameter pipe over one minute. [2] One cubic foot of water is roughly 7.48 US gallons (28.3 L; 6.23 imp gal). A Fixture Unit is used in plumbing design for both water supply and waste ...

  6. Drain (plumbing) - Wikipedia

    en.wikipedia.org/wiki/Drain_(plumbing)

    Pool drain vortex as viewed from above the water at Grange Park wading pool Underwater view of drain, showing vortex-formation phenomenon. A drain is the primary vessel or conduit for unwanted water or waste liquids to flow away, either to a more useful area, funnelled into a receptacle, or run into sewers or stormwater mains as waste discharge to be released or processed.

  7. Plug (sanitation) - Wikipedia

    en.wikipedia.org/wiki/Plug_(sanitation)

    The insertion of a plug into a drainage outlet allows the container to be filled with water or other fluids. In contrast to screw on caps, plugs are pushed into the hole and are not put over the hole. Plugs are most commonly encountered in the bathroom or kitchen, for use in bathtubs, wash basins or sinks. [1]