Ads
related to: installing tongue and groove boards
Search results
Results From The WOW.Com Content Network
Tongue and groove joints allow two flat pieces to be joined strongly together to make a single flat surface. Before plywood became common, tongue and groove boards were also used for sheathing buildings and to construct concrete formwork. A strong joint, the tongue and groove joint is widely used for re-entrant angles
Wood can be manufactured with a variety of different installation systems: Tongue-and-groove: One side and one end of the plank have a groove, the other side and end have a tongue (protruding wood along an edge's center). The tongue and groove fit snugly together, thus joining or aligning the planks, and are not visible once joined.
Matchboard by definition is "a board with a groove cut along one edge and a tongue along the other so as to fit snugly with the edges of similarly cut boards." [1]Bramble Cottage on Lundy Island, weathered cedar matchboarding in an exposed location
The small but mighty kitchen features exposed-hinge cabinetry made of tongue-and-groove pine, zinc countertops, and a showstopping 1950s cast-iron drainboard sink (found by their contractor frozen ...
A flooring clamp is used for holding tongue and groove flooring while individual boards are being face nailed. Up to 8 to 10 boards may be clamped at a time. A minimum of two are required; more is the norm. Spaced say every 4th or 5th joist.
Joiners did the finer work of installing trim and paneling. Plank and board are not consistently defined in history. Sometimes these terms are used synonymously. Board means a piece of lumber (timber) 1 ⁄ 2 inch (1.3 cm) to 1.5 inches (3.8 cm) thick and more than 4 inches (10 cm) wide.
A flat panel has its visible face flush with the front of the groove in the frame. This gives the panel an inset appearance. This style of panel is commonly made from man-made materials such as MDF or plywood but may also be made from solid wood or tongue and groove planks. Panels made from MDF will be painted to hide their appearance, but ...
A through groove (left) and a stopped groove. In joinery, a groove is a slot or trench cut into a member which runs parallel to the grain. A groove is thus differentiated from a dado, which runs across the grain. [1] Grooves are used for a range of purposes in cabinet making and other woodworking fields.