Search results
Results From The WOW.Com Content Network
Fault (geology) Satellite image of a fault in the Taklamakan Desert. The two colorful ridges (at bottom left and top right) used to form a single continuous line, but have been split apart by movement along the fault. In geology, a fault is a planar fracture or discontinuity in a volume of rock across which there has been significant ...
A thrust fault is a type of reverse fault, in which the rock above the fault is displaced upwards relative to the rock below the fault. This distinguishes reverse faults from normal faults, where the rock above the fault is displaced downwards, or strike-slip faults, where the rock on one side of the fault is displaced horizontally with respect ...
There are three main types of fault, all of which may cause an interplate earthquake: normal, reverse (thrust), and strike-slip. Normal and reverse faulting are examples of dip-slip, where the displacement along the fault is in the direction of dip and where movement on them involves a vertical component. Many earthquakes are caused by movement ...
Dip is defined as the angle of the fault relative to the surface of the earth, which indicates the plane on which slip will occur. Lastly, in any non-vertical fault, the block above the fault is called the hanging wall, while the blockbelow the fault is called the footwall. [4] Normal and reverse dip-slip faults with labeled hanging wall and ...
Focal mechanism. The focal mechanism of an earthquake describes the deformation in the source region that generates the seismic waves. In the case of a fault -related event, it refers to the orientation of the fault plane that slipped, and the slip vector and is also known as a fault-plane solution. Focal mechanisms are derived from a solution ...
A thrust fault is a type of reverse fault that has a dip of 45 degrees or less. [1][2] If the angle of the fault plane is lower (often less than 15 degrees from the horizontal [3]) and the displacement of the overlying block is large (often in the kilometer range) the fault is called an overthrust or overthrust fault. [4]
Strike-slip faults are associated with dominantly horizontal movement, leading to relatively simple linear zones of surface rupture where the fault is a simple planar structure. However, many strike-slip faults are formed of overlapping segments, leading to complex zones of normal or reverse faulting depending on the nature of the overlap.
The Puente Hills thrust fault system is the same overall fault network that produced the 1987 Whittier Narrows magnitude 5.9 earthquake, which killed eight people and caused some $358 million in ...