When.com Web Search

  1. Ads

    related to: how to calculate flow factor of soil

Search results

  1. Results From The WOW.Com Content Network
  2. Drainage equation - Wikipedia

    en.wikipedia.org/wiki/Drainage_equation

    Drainage equation. A drainage equation is an equation describing the relation between depth and spacing of parallel subsurface drains, depth of the watertable, depth and hydraulic conductivity of the soils. It is used in drainage design. A well known steady-state drainage equation is the Hooghoudt drain spacing equation.

  3. Hydraulic conductivity - Wikipedia

    en.wikipedia.org/wiki/Hydraulic_conductivity

    Hydraulic conductivity. In science and engineering, hydraulic conductivity (K, in SI units of meters per second), is a property of porous materials, soils and rocks, that describes the ease with which a fluid (usually water) can move through the pore space, or fracture network. [1]

  4. Darcy's law - Wikipedia

    en.wikipedia.org/wiki/Darcy's_law

    Darcy's law is an equation that describes the flow of a fluid through a porous medium. The law was formulated by Henry Darcy based on results of experiments [1] on the flow of water through beds of sand, forming the basis of hydrogeology, a branch of earth sciences. It is analogous to Ohm's law in electrostatics, linearly relating the volume ...

  5. Lateral earth pressure - Wikipedia

    en.wikipedia.org/wiki/Lateral_earth_pressure

    An example of lateral earth pressure overturning a retaining wall. The lateral earth pressure is the pressure that soil exerts in the horizontal direction. It is important because it affects the consolidation behavior and strength of the soil and because it is considered in the design of geotechnical engineering structures such as retaining walls, basements, tunnels, deep foundations and ...

  6. Water balance - Wikipedia

    en.wikipedia.org/wiki/Water_balance

    A general water balance equation is: [5] P = Q + ET + ΔS. where. P is precipitation. Q is streamflow. ET is evapotranspiration. ΔS is the change in storage (in soil or the bedrock / groundwater) This equation uses the principles of conservation of mass in a closed system, whereby any water entering a system (via precipitation), must be ...

  7. Runoff curve number - Wikipedia

    en.wikipedia.org/wiki/Runoff_curve_number

    The runoff curve number is based on the area's hydrologic soil group, land use, treatment and hydrologic condition. References, such as from USDA [ 1 ] indicate the runoff curve numbers for characteristic land cover descriptions and a hydrologic soil group. The runoff equation is: where. has a range from 30 to 100; lower numbers indicate low ...

  8. Atterberg limits - Wikipedia

    en.wikipedia.org/wiki/Atterberg_limits

    Atterberg limits. The Atterberg limits are a basic measure of the critical water contents of a fine-grained soil: its shrinkage limit, plastic limit, and liquid limit. Depending on its water content, soil may appear in one of four states: solid, semi-solid, plastic and liquid. In each state, the consistency and behavior of soil are different ...

  9. Infiltration (hydrology) - Wikipedia

    en.wikipedia.org/wiki/Infiltration_(hydrology)

    Infiltration (hydrology) Cross-section of a hillslope depicting the vadose zone, capillary fringe, water table, and phreatic or saturated zone. (Source: United States Geological Survey.) Infiltration is the process by which water on the ground surface enters the soil. It is commonly used in both hydrology and soil sciences.