Search results
Results From The WOW.Com Content Network
The density of water is approximately 1000 g/L and its molar mass is 18.02 g/mol (or 1/18.02 = 0.055 mol/g). Therefore, the molar concentration of water is c(H 2 O) = 1000 g/L / 18.02 g/mol ≈ 55.5 mol/L. Likewise, the concentration of solid hydrogen (molar mass = 2.02 g/mol) is c(H 2) = 88 g/L / 2.02 g/mol = 43.7 mol/L. The ...
For example, sulfuric acid (H 2 SO 4) is a diprotic acid. Since only 0.5 mol of H 2 SO 4 are needed to neutralize 1 mol of OH −, the equivalence factor is: f eq (H 2 SO 4) = 0.5. If the concentration of a sulfuric acid solution is c(H 2 SO 4) = 1 mol/L, then its normality is 2 N. It can also be called a "2 normal" solution.
The ideal gas equation can be rearranged to give an expression for the molar volume of an ideal gas: = = Hence, for a given temperature and pressure, the molar volume is the same for all ideal gases and is based on the gas constant: R = 8.314 462 618 153 24 m 3 ⋅Pa⋅K −1 ⋅mol −1, or about 8.205 736 608 095 96 × 10 −5 m 3 ⋅atm⋅K ...
The following table lists the Van der Waals constants (from the Van der Waals equation) for a number of common gases and volatile liquids. [ 1 ] To convert from L 2 b a r / m o l 2 {\displaystyle \mathrm {L^{2}bar/mol^{2}} } to L 2 k P a / m o l 2 {\displaystyle \mathrm {L^{2}kPa/mol^{2}} } , multiply by 100.
The equation can only be applied when the purged volume of vapor or gas is replaced with "clean" air or gas. For example, the equation can be used to calculate the time required at a certain ventilation rate to reduce a high carbon monoxide concentration in a room.
Formula Sheet Equation Editor [permanent dead link ] Yes Yes No Yes Yes Yes No No Online LaTeX equation editor with real-time .png, .pdf, and .tex output. Customizable resolution, font, and color. One click copy to MS Word 2007+ using MathML. Formulator MathML Weaver: Yes Yes No No Yes Yes No No Dual-licensing (Open source and commercial).
where A and B are reactants C is a product a, b, and c are stoichiometric coefficients,. the reaction rate is often found to have the form: = [] [] Here is the reaction rate constant that depends on temperature, and [A] and [B] are the molar concentrations of substances A and B in moles per unit volume of solution, assuming the reaction is taking place throughout the volume of the ...
For example, replacing m with q (total charge) and m 0 with q 0 (charge of each object) in the above equation will lead to a correct expression for charge. The number density of solute molecules in a solvent is sometimes called concentration , although usually concentration is expressed as a number of moles per unit volume (and thus called ...