Search results
Results From The WOW.Com Content Network
ifconfig (short for interface config) is a system administration utility in Unix-like operating systems for network interface configuration. The utility is a command-line interface tool and is also used in the system startup scripts of many operating systems. It has features for configuring, controlling, and querying TCP/IP network interface ...
On Linux and all Unix-like operating systems, the utilities ifconfig and the newer ip (from the iproute2-bundle) are used to configure IEEE 802.3 and IEEE 802.11 hardware. These utilities configure the kernel directly and the configuration is applied immediately. After boot-up, the user is required to configure them again.
ipconfig in Mac OS X serves as a wrapper to the IPConfiguration agent, and can be used to control the Bootstrap Protocol and DHCP client from the command-line interface. [8] For example, you can release and renew an IP address if it happened to be assigned incorrectly by the DHCP server during the automated assignment process. [9]
The configuration software of choice is then used to configure the persistent configuration which is applied on boot. It is also possible to configure Linux networking ad-hoc using the ip command from the iproute2 package. The following command can be used to configure the route using ip: [10]
Link-local addresses may be assigned manually by an administrator or by automatic operating system procedures. In Internet Protocol (IP) networks, they are assigned most often using stateless address autoconfiguration, a process that often uses a stochastic process to select the value of link-local addresses, assigning a pseudo-random address that is different for each session.
COMMAND: The command to run (add, delete, change, get, monitor, flush)-net: <dest> is a network address-host: <dest> is host name or address (default)-netmask: the mask of the route <dest>: IP address or host name of the destination <gateway>: IP address or host name of the next-hop router
A command prompt (or just prompt) is a sequence of (one or more) characters used in a command-line interface to indicate readiness to accept commands. It literally prompts the user to take action. A prompt usually ends with one of the characters $ , % , # , [ 18 ] [ 19 ] : , > or - [ 20 ] and often includes other information, such as the path ...
In Linux, the parameter is called net.ipv4.ip_forward. In most systems, the command sysctl -w parameter=1 will enable a certain behavior. This will persist until the next reboot. If the behavior should be enabled whenever the system boots, the line parameter=1 can be added/rewritten to the file /etc/sysctl.conf. Additionally, some sysctl ...