Search results
Results From The WOW.Com Content Network
The alarm transmission methods covered under UL 365 can be categorized under standard line security or encrypted line security. The systems are required to operate within the limits of Class 2 remote control and signal circuits as defined by the National Electrical Code, NFPA 70.
However, studies have found that wear coefficient is more suitable. The reason being that it takes the wear rate, the applied load, and the hardness of the wear pin into account. Although, measurement variations by an order of 10-1 have been observed, the variations can be minimized if suitable precautions are taken.
A fire alarm system is a building system designed to detect, alert occupants, ... and service of fire detection and fire alarm systems in and around a building. This ...
The friction coefficient is an empirical (experimentally measured) structural property that depends only on various aspects of the contacting materials, such as surface roughness. The coefficient of friction is not a function of mass or volume. For instance, a large aluminum block has the same coefficient of friction as a small aluminum block.
The primary data set used in cost distance analysis is the cost raster, sometimes called the cost-of-passage surface, [9] the friction image, [8] the cost-rate field, or cost surface. In most implementations, this is a raster grid , in which the value of each cell represents the cost (i.e., expended resources, such as time, money, or energy) of ...
A short piece of fire hose, usually 10 to 20 feet (6.1 m) long, of large diameter, greater than 2.5 inches (64 mm) and as large as 6 inches (150 mm), used to move water from a fire hydrant to the fire engine, when the fire apparatus is parked close to the hydrant.
The former is concerned with static friction (also known as "stiction" [3]) or "limiting friction", whilst the latter is dynamic friction, also called "sliding friction". For steel on steel, the coefficient of friction can be as high as 0.78, under laboratory conditions, but typically on railways it is between 0.35 and 0.5, [ 4 ] whilst under ...
An optical beam smoke detector is a device that uses a projected beam of light to detect smoke across large areas, [1] typically as an indicator of fire. [2] They are used to detect fires in buildings where standard point smoke detectors would either be uneconomical [ 3 ] or restricted for use by the height of the building.