Ad
related to: airplane slats vs flaps
Search results
Results From The WOW.Com Content Network
Trailing edge flaps extended on the right on a typical airliner (an Airbus A310-300). Leading edge slats are also extended, on the left. A flap is a high-lift device used to reduce the stalling speed of an aircraft wing at a given weight. Flaps are usually mounted on the wing trailing edges of a fixed-wing aircraft. Flaps are used to reduce the ...
The spring-loaded slat lies flush with the wing leading edge, held in place by the force of the air acting on them. As the aircraft slows down, the aerodynamic force is reduced and the springs extend the slats. Sometimes referred to as Handley-Page slats. Fixed The slat is permanently extended.
Flaps raise the maximum lift coefficient of the aircraft and therefore reduce its stalling speed. [5] They are used during low speed, high angle of attack flight including take-off and descent for landing. Some aircraft are equipped with "flaperons", which are more commonly called "inboard ailerons" [citation needed]. These devices function ...
Droop flaps function with other high-lift devices on an aircraft to increase the camber of the wing and reduce the stalling speed.On the Airbus A380, the first stage of lift device selection deploys the droop flaps (called droop noses by Airbus) and leading-edge slats located further out on the wing; with the main flaps starting to extend when the second stage is selected.
In aircraft design and aerospace engineering, a high-lift device is a component or mechanism on an aircraft's wing that increases the amount of lift produced by the wing. The device may be a fixed component, or a movable mechanism which is deployed when required. Common movable high-lift devices include wing flaps and slats.
A leading-edge slat is an aerodynamic surface running spanwise just ahead of the wing leading edge. It creates a leading edge slot between the slat and wing which directs air over the wing surface, helping to maintain smooth airflow at low speeds and high angles of attack. This delays the stall, allowing the aircraft to fly at a higher angle of ...
Krueger flaps deployed from the leading edge of a Boeing 747 (top left and right in photo). Krueger flaps, or Krüger flaps, are lift enhancement devices that may be fitted to the leading edge of an aircraft wing. Unlike slats or droop flaps, the main wing upper surface and its leading edge is not changed. Instead, a portion of the lower wing ...
Similar, but retractable, leading-edge devices are called slats. [4] When the slat opens, it creates a slot between the slat and the remainder of the wing; retracted, the drag is reduced. A fixed leading-edge slot can increase the maximum lift coefficient of an airfoil section by 40%. In conjunction with a slat, the increase in maximum lift ...