Search results
Results From The WOW.Com Content Network
The diagram on the left shows the effect on the spectrum if a trapezoid pulse profile is adopted. It can be seen that the energy in the sidebands is significantly reduced compared to the main lobe and the amplitude of the main lobe is increased. Radar transmission frequency spectrum of a cosine pulse profile
A pencil-beam radar A moving or sweeping pencil-beam radar. In optics, a pencil or pencil of rays, also known as a pencil beam or narrow beam, is a geometric construct (pencil of half-lines) used to describe a beam or portion of a beam of electromagnetic radiation or charged particles, typically in the form of a cone or cylinder.
The radar mile is the time it takes for a radar pulse to travel one nautical mile, reflect off a target, and return to the radar antenna. Since a nautical mile is defined as 1,852 m, then dividing this distance by the speed of light (299,792,458 m/s), and then multiplying the result by 2 yields a result of 12.36 μs in duration.
Stacked beam radars emit and/or receive multiple beams of radio waves at two or more elevation angles. By comparing the relative strengths of the returns from each beam, the elevation of the target can be deduced. An example of a stacked beam radar is the Air Route Surveillance Radar.
The radar horizon is a critical area of performance for aircraft detection systems, defined by the distance at which the radar beam rises enough above the Earth's surface to make detection of a target at the lowest level possible.
Typical RCS diagram (A-26 Invader) Radar cross-section (RCS), denoted σ, also called radar signature, is a measure of how detectable an object is by radar. A larger RCS indicates that an object is more easily detected. [1] An object reflects a limited amount of radar energy back to the source. The factors that influence this include: [1]
Monopulse radar is a radar system that uses additional encoding of the radio signal to provide accurate directional information. The name refers to its ability to extract range and direction from a single signal pulse. Monopulse radar avoids problems seen in conical scanning radar systems, which can be confused by rapid changes in signal strength.
Conical scanning concept. The radar beam is rotated in a small circle around the "boresight" axis, which is pointed at the target. Conical scanning is a system used in early radar units to improve their accuracy, as well as making it easier to steer the antenna properly to point at a target.