Ads
related to: cost to install retaining wall caps pictures to wood posts plans free
Search results
Results From The WOW.Com Content Network
A basement wall is thus one kind of retaining wall; however, the term usually refers to a cantilever retaining wall, which is a freestanding structure without lateral support at its top. [2] These are cantilevered from a footing and rise above the grade on one side to retain a higher level grade on the opposite side.
Poteaux-en-terre (posts in ground) is a type of timber framing with the many vertical posts or studs buried in the ground called post in ground or "earthfast" construction. The tops of the posts are joined to a beam and the spaces between are filled in with natural materials called bousillage or pierrotage.
Intermediate – A post in an exterior wall not at a corner. Chimney – An intermediate post receiving its name from being near a chimney. Interior – A general term for posts not in an exterior wall. Arcade – A post located between an aisle and nave. [10] Aisle – same as arcade post. [11] Corner – Any post at the corner of a building.
Comparison of a ha-ha (top) and a regular wall (bottom). Both walls prevent access, but one does not block the view looking outward. A ha-ha (French: hâ-hâ [a a] ⓘ or saut de loup [so də lu] ⓘ), also known as a sunk fence, blind fence, ditch and fence, deer wall, or foss, is a recessed landscape design element that creates a vertical barrier (particularly on one side) while preserving ...
Upon installation, tiebacks are tested and usually pre-loaded. In specific, a combination of proof tests and performance tests are performed on every job. Proof testing involves the application of successively larger loads on the tieback with a loading jack, allowing for the recording of a load-elongation curve according to gauge readings.
Wall framing in house construction includes the vertical and horizontal members of exterior walls and interior partitions, both of bearing walls and non-bearing walls. . These stick members, referred to as studs, wall plates and lintels (sometimes called headers), serve as a nailing base for all covering material and support the upper floor platforms, which provide the lateral strength along a
Return wing walls: used where banks are high and hard or firm. Their top width is 1.5 m and face is vertical and back battered 1 in 4. [ 2 ] Scour can be a problem for wing walls and abutments both, as the water in the stream erodes the supporting soil.
A pile cap is a thick concrete mat that rests on concrete or timber piles that have been driven into soft or unstable ground to provide a suitable stable foundation. It usually forms part of the deep foundation of a building, typically a multi-story building, structure or support base for heavy equipment, or of a bridge.