When.com Web Search

  1. Ads

    related to: cost to install foundation vents in brick house in dallas texas

Search results

  1. Results From The WOW.Com Content Network
  2. In Texas, watering your home’s concrete foundation can save ...

    www.aol.com/news/texas-watering-home-concrete...

    The foundation is one of the first things set when building a house. Concrete is poured and reinforced with steel rods. The structure serves as the ground floor of the house and supports ...

  3. Basement waterproofing - Wikipedia

    en.wikipedia.org/wiki/Basement_waterproofing

    The Federal Emergency Management Agency (FEMA) recommends basement waterproofing with a water alarm and "battery-operated backup pump" as a preventive measure against the high cost of flooding. [2] Wall conduits (such as dimple boards or other membranes) are fastened to the foundation wall and extend over the new drainage to guide any moisture ...

  4. Orangeburg pipe - Wikipedia

    en.wikipedia.org/wiki/Orangeburg_pipe

    Orangeburg was a low cost alternative to metal for sewer lines in particular. Lack of strength causes pipes made of Orangeburg to fail more frequently than pipes made with other materials. The useful life for an Orangeburg pipe is about 50 years under ideal conditions, but has been known to fail in as little as 10 years.

  5. Drain-waste-vent system - Wikipedia

    en.wikipedia.org/wiki/Drain-waste-vent_system

    In the U.S., every plumbing fixture must also be coupled to the system's vent piping. [1] Without a vent, negative pressure can slow the flow of water leaving the system, resulting in clogs, or cause siphonage to empty a trap. The high point of the vent system (the top of its "soil stack") must be open to the exterior at atmospheric pressure.

  6. In Texas, watering your home’s concrete foundation this ...

    www.aol.com/texas-watering-home-concrete...

    For premium support please call: 800-290-4726 more ways to reach us

  7. Register (air and heating) - Wikipedia

    en.wikipedia.org/wiki/Register_(air_and_heating)

    Ideally, a room will have both heating and cooling registers. In practice, cost considerations usually require that heating and cooling be provided by the same register. In such cases, heating most often takes precedence over cooling, and registers are usually found close to the floor. [7] For heating purposes, a floor register is preferred.