Ad
related to: 6r80 output speed sensor location 2 wd drive
Search results
Results From The WOW.Com Content Network
The 6R is a 6-speed automatic transmission for longitudinal engine placement in rear-wheel drive vehicles. It is based on the ZF 6HP26 transmission [1] and has been built under license by the Ford Motor Company at its Livonia Transmission plant in Livonia, Michigan.
The Ford Ranger (T6) is a range of mid-size pickup trucks manufactured and sold by Ford Motor Company since 2011. The T6 consolidated worldwide production of the Ranger onto a single model range, replacing both the 1998–2012 Ranger marketed in North America and South America and the Mazda-derived Ranger sold in Asia-Pacific, Europe, and several Latin American markets.
Automatic – once placed in drive (or any other 'automatic' selector position), it automatically selects the gear ratio dependent on engine speed and load; Basically there are two types of engine installation: In the longitudinal direction, the gearbox is usually designed separately from the final drive (including the differential). The ...
Expedition's 6-speed 6R75 automatic was replaced by an improved version, the 6-speed 6R80 automatic. It features more robust internals, new software logic, and a tow/haul mode (replacing the overdrive lock-out) that utilizes new uphill/downhill gradient shift logic for improved performance while towing or hauling heavy loads.
The TPS sensor along with the vehicle speed sensor are the two main inputs for most TCUs. Older transmissions use this to determine engine load, with the introduction of drive-by-wire technology, this is often a shared input between the ECU and TCU. The input is used to determine the optimum time and characteristics for a gear change according ...
As the selected gearset concept saves up to 2 components compared to 5-speed transmissions, the advantages clearly outweigh the disadvantages. It has a torque converter lock-up for all 6 forward gears, which can be fully disengage when stationary, largely closing the fuel efficiency gap between vehicles with automatic and manual transmissions .
The Ford–GM 10-speed automatic transmission is part of a joint venture between Ford Motor Company and General Motors to design and engineer two transmissions: a longitudinal 10-speed transmission and a transverse 9-speed trans-axle. Each company manufactures its own unique version of the transmissions in its own factories.
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]