When.com Web Search

  1. Ads

    related to: who has best bandsaw blades for resawing sale

Search results

  1. Results From The WOW.Com Content Network
  2. Resaw - Wikipedia

    en.wikipedia.org/wiki/Resaw

    Resaw blades used in a sawmill. A resaw is a large band saw optimized for cutting timber along the grain to reduce larger sections into smaller sections or veneers. Resawing veneers requires a wide blade – commonly 2 to 3 inches (52–78 mm) – with a small kerf to minimize waste. Resaw blades of up to 1 inch (26 mm) may be fitted to a ...

  3. Bandsaw - Wikipedia

    en.wikipedia.org/wiki/Bandsaw

    A resaw is a large bandsaw optimized for cutting timber along the grain to reduce larger sections into smaller sections or veneers. Resawing veneers requires a wide blade—commonly 2 to 3 in (51 to 76 mm)—with a small kerf to minimize waste. Resaw blades of up to 1 in (25 mm) may be fitted to a standard bandsaw.

  4. Bandsaw box - Wikipedia

    en.wikipedia.org/wiki/Bandsaw_box

    Relief cuts are always needed if you are going to make a bandsaw box. If you don't, the box always seems to fall apart. If the bandsaw has a little hitch in it the box usually snaps in two. There are multiple techniques for constructing band saw boxes. The primary technique starts by cutting the main shape of the box.

  5. Circular saw - Wikipedia

    en.wikipedia.org/wiki/Circular_saw

    Portable sawmill circular saw blade about 60 cm (2.0 ft) diameter. Originally, circular saws in mills had smaller blades and were used to resaw lumber after it passed through an "up and down" (muley or sash) saw leaving both vertical and circular saw marks on different sides of the same piece.

  6. Saw - Wikipedia

    en.wikipedia.org/wiki/Saw

    The basic version has a circular blade fixed at a 90° angle to the vertical. A "compound miter saw" has a blade that can be adjusted to other angles. A "sliding compound miter saw" has a blade that can be pulled through the work, in an action similar to that of a radial-arm saw, which provides more capacity for cutting wider workpieces.

  7. Backsaw - Wikipedia

    en.wikipedia.org/wiki/Backsaw

    The work of a backsaw requires a thin, stiff blade. These two immediately incompatible requirements are resolved by swaging (and perhaps, spot welding) a stiffening cap over the length of the top edge of the blade. This thickening of the blade is the back and is generally made from some kind of metal, usually brass or steel.

  1. Ad

    related to: who has best bandsaw blades for resawing sale