Search results
Results From The WOW.Com Content Network
A Marsh funnel is a Marsh cone with a particular orifice and a working volume of 1.5 litres. It consists of a cone 6 inches (152 mm) across and 12 inches in height (305 mm) to the apex of which is fixed a tube 2 inches (50.8 mm) long and 3/16 inch (4.76 mm) internal diameter. A 10-mesh screen is fixed near the top across half the cone. [2]
Decanter centrifuges with the same diameter but the longer length would have a higher capacity for conveying solids and attain a larger suspension volume, which would enhance the settling out of fine solids. [10] The beach angle at the conical section of a decanter centrifuge is a design heuristic, which must also be taken into consideration.
Both the conical plate centrifuge and chamber bowl centrifuge can be used for liquid/liquid and solid/liquid separation. However, the advantage of conical plate centrifuge over chamber bowl centrifuge is that solid discharge is possible in conical plate. The chamber bowl has a high capacity for solids but there is no solid discharge.
The standard Imhoff cone of transparent glass or plastic holds one liter of liquid and has calibrated markings to measure the volume of solids accumulated in the bottom of the conical container after settling for one hour. A standardized Imhoff cone procedure is commonly used to measure suspended solids in wastewater or stormwater runoff.
The cone acts as a conditioning device as well as a differential pressure producer. Upstream requirements are between 0–5 diameters compared to up to 44 diameters for an orifice plate or 22 diameters for a Venturi. Because cone meters are generally of welded construction, it is recommended they are always calibrated prior to service.
The area required to calculate the volumetric flow rate is real or imaginary, flat or curved, either as a cross-sectional area or a surface. The vector area is a combination of the magnitude of the area through which the volume passes through, A , and a unit vector normal to the area, n ^ {\displaystyle {\hat {\mathbf {n} }}} .
Vessel dished ends are mostly used in storage or pressure vessels in industry. These ends, which in upright vessels are the bottom and the top, use less space than a hemisphere (which is the ideal form for pressure containments) while requiring only a slightly thicker wall.
A conical measure is a type of laboratory glassware which consists of a conical cup with a notch on the top to allow for the easy pouring of liquids, and graduated markings on the side to allow easy and accurate measurement of volumes of liquid. They may be made of plastic, glass, or borosilicate glass. The use of the conical measure usually ...