Search results
Results From The WOW.Com Content Network
A cap screw with a socket head (usually implying a hex socket, driven with a hex key. SHN: shown: See Part number > Symmetrical parts for explanation. SHSS: socket head set screw: A set screw with a socket head (usually implying a hex socket, driven with a hex key. SI: Système international [d'unités] [International System of Units]
An elevator bolt is a similar to a carriage bolt, except the head (or foot, depending on the application) is thin and flat. There are many variations. [11] Elevator bolts are designed to be used for leveling appliances or furniture. eye bolt: An eye bolt is a bolt with a looped head.
A screw thread, often shortened to thread, is a helical structure used to convert between rotational and linear movement or force. A screw thread is an inclined plane wrapped around a cylinder or cone in the form of a helix, with the former being called a straight thread and the latter called a tapered thread.
The hex head is used to drive the bolt into the countersunk hole, then either a wrench or hammer is used to break the shank and hex head from the flat head, or it is driven until the driving head shears off. Either method leaves only a smooth bolt head exposed. This type of bolt is commonly used with prison door locks, automobile ignition ...
The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than 1 / 4 inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.
Bolts use a wide variety of head designs, as do screws. These are designed to engage with the tool used to tighten them. Some bolt heads instead lock the bolt in place, so that it does not move and a tool is only needed for the nut end. Common bolt heads include hex, slotted hex washer, and socket cap.
Note that AN threads are different for bolts and fittings. In bolts the number refers to the diameter of the bolt whereas in a fitting it refers to the OD of the tube and thereby have different threads. For example, AN6 bolt has a 3 ⁄ 8-24 thread [3] whereas an -6 AN fitting has a 9 ⁄ 16-18 thread. [4]
ASTM A325 is an ASTM International standard for heavy hex structural bolts, titled Standard Specification for Structural Bolts, Steel, Heat Treated, 120/105 ksi Minimum Tensile Strength. It defines mechanical properties for bolts that range from 1 ⁄ 2 to 1 + 1 ⁄ 2 inches (13 to 38 mm) in diameter.