Search results
Results From The WOW.Com Content Network
The TRIAC's gate can be connected through an opto-isolated transistor, and sometimes a resistor to the microcontroller, so that bringing the voltage down to the microcontroller's logic zero pulls enough current through the TRIAC's gate to trigger it. This ensures that the TRIAC is triggered in quadrants II and III and avoids quadrant IV where ...
Zero-crossing control (or burst-fire control) is an approach for electrical control circuits that starts operation with the AC load voltage at close to 0 volts in the AC cycle. [1] This is in relation to solid-state relays, such as TRIACs and silicon controlled rectifiers. [1]
A Triggering device is an electronic circuit, such as a Schmitt trigger, ... Both silicon-controlled rectifiers (SCR) and TRIACs are members of the thyristor family.
Three-layer DIAC. The DIAC (diode for alternating current) is a diode that conducts electrical current only after its breakover voltage, V BO, has been reached momentarily. Three, four, and five layer structures may be used. [1] Behavior is similar to the voltage breakdown of a triac without a gate terminal.
Phase-fired controllers take their name from the fact that they trigger a pulse of output at a certain phase of the input's modulation cycle. In essence, a PFC is a controller that can synchronise itself with the modulation present at the input.
A QUADRAC is a special type of thyristor which combines a DIAC and a TRIAC in a single package. The DIAC is the triggering device for the TRIAC. Thyristors are four-layer (PNPN) semiconductor devices that act as switches, rectifiers or voltage regulators in a variety of applications. When triggered, thyristors turn on and become low-resistance ...
A circuit protection device for overhead power distribution lines which briefly interrupts a circuit when a fault is detected, then restores the circuit in the expectation the fault has cleared. autotransformer A transformer where the primary and secondary circuits share some of the transformer windings. availability factor
Forward-voltage triggering occurs when the anode–cathode forward voltage is increased with the gate circuit opened. This is known as avalanche breakdown, during which junction J2 will break down. At sufficient voltages, the thyristor changes to its on state with low voltage drop and large forward current.