Search results
Results From The WOW.Com Content Network
The grain per gallon (gpg) is a unit of water hardness defined as 1 grain (64.8 milligrams) of calcium carbonate dissolved in 1 US gallon of water (3.785412 L). It translates into 1 part in about 58,000 parts of water or 17.1 parts per million (ppm). Also called Clark degree (in terms of an imperial gallon).
Although ppmv and grains per dscf have been used in the above examples, concentrations such as ppbv (i.e., parts per billion by volume), volume percent, grams per dscm and many others may also be used. 1 percent by volume = 10,000 ppmv (i.e., parts per million by volume).
Parts per million (ppm) is usually defined as 1 mg/L CaCO 3 (the definition used below). [20] It is equivalent to mg/L without chemical compound specified, and to American degree . Grain per gallon (gpg) is defined as 1 grain (64.8 mg) of calcium carbonate per U.S. gallon (3.79 litres), or 17.118 ppm.
In a solution where only CO 2 affects the pH, carbonate hardness can be used to calculate the concentration of dissolved CO 2 in the solution with the formula CO 2 = 3 × KH × 10 (7-pH), where KH is degrees of carbonate hardness and CO 2 is given in ppm by weight. [citation needed]
[14] [15] Otherwise, water hardness is measured in the dimensionless unit of parts per million (ppm), numerically equivalent to concentration measured in milligrams per litre. [14] [15] One grain per U.S. gallon is approximately 17.1 ppm. [14] [note 1] Soft water contains 1–4 gpg of calcium carbonate equivalents, while hard water contains 11 ...
Some TDS meters use an electrical conductivity measurement to the ppm using the above formula. Regarding units, 1 ppm indicates 1 mg of dissolved solids per 1,000 g of water. Regarding units, 1 ppm indicates 1 mg of dissolved solids per 1,000 g of water.
A variety of hardness-testing methods are available, including the Vickers, Brinell, Rockwell, Meyer and Leeb tests. Although it is impossible in many cases to give an exact conversion, it is possible to give an approximate material-specific comparison table for steels .
In water testing hardness is often measured in parts per million (ppm), where one part per million is defined as one milligram of calcium carbonate (CaCO 3) per litre of water. Consequently, 1 dGH corresponds to 10 ppm CaO but 17.848 ppm CaCO 3 which has a molar mass of 100.09 g/mol.