Ads
related to: recessed concrete floor tie downs for saleuline.com has been visited by 1M+ users in the past month
Search results
Results From The WOW.Com Content Network
A hold-down may also refer to clamping device used to anchor a pipe to a structural steel element or concrete floor or allow movement of the pipe in an axial direction. [1] At the bottom, the hold down is connected to the concrete foundation or structural slab by an embedded or epoxied anchor bolt. At the top, the hold down is connected to a ...
Beam and block is a construction method to support flooring, especially for ground floors as well as multi story buildings. [1] It is made of cast concrete, one piece of which is a prestressed concrete beam, which can be an inverted T-shaped beam, or lintel, the other piece being a simple rectangular block. [1]
An anchor plate, floor plate [1] or wall washer is a large plate or washer connected to a tie rod or bolt. Anchor plates are used on exterior walls of masonry buildings, for structural reinforcement against lateral bowing. Anchor plates are made of cast iron, sometimes wrought iron or steel, and are often made in a decorative style. [2]
Grouted tiebacks can be constructed as steel rods drilled through a concrete wall out into the soil or bedrock on the other side. Grout is then pumped under pressure into the tieback anchor holes to increase soil resistance and thereby prevent tiebacks from pulling out, reducing the risk for wall destabilization.
Mortar is recessed increasingly from the bottom to the top of the joint, with the top end not receding more than 3/8-inch into the wall. The straight, inclined surfaces of the bed (horizontal) joints tend to catch the light and give the brickwork a neat, ordered appearance.
Cellular floor raceways are electrical wiring ducts or cells made from steel floor deck that serve as structural formwork for placement of concrete floor slabs and also as wire and cable raceways within the concrete floor slab.
A hurricane tie used to fasten a rafter to a stud. A tie, strap, tie rod, eyebar, guy-wire, suspension cables, or wire ropes, are examples of linear structural components designed to resist tension. [1] It is the opposite of a strut or column, which is designed to resist compression. Ties may be made of any tension resisting material.
A concrete slab is a common structural element of modern buildings, consisting of a flat, horizontal surface made of cast concrete. Steel- reinforced slabs, typically between 100 and 500 mm thick, are most often used to construct floors and ceilings, while thinner mud slabs may be used for exterior paving ( see below ).