Search results
Results From The WOW.Com Content Network
Cisco Inter-Switch Link (ISL) is a Cisco proprietary link layer protocol that maintains VLAN information in Ethernet frames as traffic flows between switches and routers, or switches and switches. [1] ISL is Cisco's VLAN encapsulation protocol and is supported only on some Cisco equipment over the Fast and Gigabit Ethernet links. It is offered ...
InterSwitch Trunk (IST) is one or more parallel point-to-point links (Link aggregation) that connect two switches together to create a single logical switch.The IST allows the two switches to share addressing information, forwarding tables, and state information, permitting rapid (less than one second) fault detection and forwarding path modification.
Inter-Switch Link (ISL) is a Cisco proprietary protocol used to interconnect switches and maintain VLAN information as traffic travels between switches on trunk links. ISL is provided as an alternative to IEEE 802.1Q. ISL is available only on some Cisco equipment and has been deprecated. [11]
This is known as inter-VLAN routing. On layer-3 switches it is accomplished by the creation of layer-3 interfaces (SVIs). Inter VLAN routing, in other words routing between VLANs, can be achieved using SVIs. [1] SVI or VLAN interface, is a virtual routed interface that connects a VLAN on the device to the Layer 3 router engine on the same device.
Inter-Switch Link can stand for: The link joining of two Fibre Channel switches through E_ports; Cisco Inter-Switch Link (ISL) is a proprietary protocol that maintains VLAN information as traffic flows between switches and routers.
Router R1 is a one-armed router carrying out inter-VLAN routing. A router on a stick, also known as a one-armed router, [1] [2] is a router that has a single physical or logical connection to a network. It is a method of inter-VLAN routing where one router is connected to a switch via a single cable. The router has physical connections to the ...
If a packet is sent to 203.0.113.1 by a computer at 192.168.1.100, the packet would normally be routed to the default gateway (the router) [e] A router with the NAT loopback feature detects that 203.0.113.1 is the address of its WAN interface, and treats the packet as if coming from that interface. It determines the destination for that packet ...
In addition, a compatibility switch feature [9] allows fine-grained interoperability adjustments. In an effort to avoid unnecessary load on hosts that do not participate in routing, RIPv2 multicasts the entire routing table to all adjacent routers at the address 224.0.0.9, as opposed to RIPv1 which uses broadcast.