Search results
Results From The WOW.Com Content Network
In this technique, high frequency performance is achieved by using two cores without air gaps. One of the two main cores is used to create a saturable inductor and the other is used to create a high frequency transformer effect. In another approach, three cores can be used without air gap.
The PD happens near the peak voltage both positive and negative. PD pulses are easy to measure using the high frequency current transducer (HFCT) method. The current transducer is clamped around the case ground of the component being tested. The severity of the PD is measured by measuring the burst interval between the end of a burst and the ...
Practical charge amplifiers usually include additional stages like voltage amplifiers, transducer sensitivity adjustment, high and low pass filters, integrators and level monitoring circuits. The charge signals at the input of a charge amplifier can be as low as some fC (FemtoCoulomb = 10 −15 C). A parasitic effect of common coaxial sensor ...
The picture shows a Rogowski coil encircling a current-carrying cable. The output of the coil, v(t), is connected to a lossy integrator circuit to obtain a voltage V out (t) that is proportional to I(t). A Rogowski coil, named after Walter Rogowski, is an electrical device for measuring alternating current (AC) or high
Hall effect current sensor with internal integrated circuit amplifier. 8 mm opening. Zero current output voltage is midway between the supply voltages that maintain a 4 to 8-volt differential. The non-zero current response is proportional to the voltage supplied and is linear to 60 amperes for this particular (25 A) device.
As CMUTs are micromachined devices, it is easier to construct 2D arrays of transducers using this technology. This means large numbers of CMUTs could be included in a transducer array providing larger bandwidth compared to other transducer technologies. To achieve a high frequency operation using CMUTs is easier due to its smaller dimensions. [2]
Magnetic amplifiers were used to control large high-power alternators by turning them on and off for telegraphy or to vary the signal for voice modulation. The alternator's frequency limits were rather low to where a frequency multiplier had to be utilized to generate higher radio frequencies than the alternator was capable of producing.
A transducer is a device that converts energy from one form to another. Usually a transducer converts a signal in one form of energy to a signal in another. [1] Transducers are often employed at the boundaries of automation, measurement, and control systems, where electrical signals are converted to and from other physical quantities (energy, force, torque, light, motion, position, etc.).