Ads
related to: slant 6 turbo setup manual
Search results
Results From The WOW.Com Content Network
The Slant-Six is the popular name for a Chrysler inline-6 internal combustion engine with an overhead valve reverse-flow cylinder head and cylinder bank inclined at a 30-degree angle from vertical. Introduced in 1959 for the 1960 models, it was known within Chrysler as the G-engine .
The first version of this engine family was a normally aspirated 2.2 L (134 cu in) unit. Developed under the leadership of Chief Engineer – Engine Design and Development Willem Weertman and head of performance tuning Charles "Pete" Hagenbuch, who had worked on most of Chrysler's V-8 engines and the Chrysler Slant-6 engine, [1] it was introduced in the 1981 Dodge Aries, Dodge Omni, Plymouth ...
The Hemi-6 valves are angled apart (splayed) 18 degrees (included angle) along the crankshaft axis, and the intake valves are as large as 1.96 in (50 mm). The 6 intake and 6 exhaust valves open slightly towards each other and away from the cylinder wall, which results in less "shrouding" of the valves and greater airflow potential.
The standard engine was a 225 cu in (3.7 L) Slant Six. 318 cu in (5.2 L) and 360 cu in (5.9 L ... Many manual transmissions were offered throughout the years ...
175 bhp 225 cu in (3.7 L) "High Compression" Slant-six; 210 bhp 318 cu in (5.2 L) V8 [2] 230 bhp 318 cu in (5.2 L) "Fireball" V8 [2] The “High Compression” six was fitted to the Pacer and was not available in other models. [2] The "Fireball" V8 was standard on Regal 770 models. [2] Two transmissions were available. [2] Three speed manual [2]
The engine was especially suited for transverse applications in Chrysler's minivans, but was also used in a longitudinal front-wheel-drive setup on 1993-1997 LH platform cars. It was last used in 2010 for Chrysler minivans before the introduction of the new 3.6 L Pentastar engine for the 2011 model year.
During World War II, the 251 cu in (4,107 cc) flathead six was used as the basis for the Chrysler A57 multibank tank engine. [5] The last automotive use of the Chrysler flathead inline-six was in 1968. It was replaced by the much more efficient OHV Slant-6 released in 1960, which appeared in most Dodge trucks starting in 1961. According to the ...
Its block was bored out to 4.04 in (102.6 mm) but its 3.31 in (84.1 mm) stroke left unchanged, resulting in the 340 cu in (5.6 L) engine introduced for the 1968 model year. Anticipating higher loads resulting from racing operation, the engineers fitted a forged shot peened steel crankshaft instead of the cast steel unit used in the 318. This ...