When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Grinder pump - Wikipedia

   en.wikipedia.org/wiki/Grinder_pump

   Grinder pumps can be installed in the basement or in the yard. If installed in the yard, the holding tank must be buried deep enough that the pump and sewage pipes are below the frost line. A grinder pump is different from a sump pump or effluent pump. There are two types of grinder pumps, semi-positive displacement (SPD) and centrifugal.

3. Grinding (abrasive cutting) - Wikipedia

   en.wikipedia.org/wiki/Grinding_(abrasive_cutting)

   The five types of cylindrical grinding are: outside diameter (OD) grinding, inside diameter (ID) grinding, plunge grinding, creep feed grinding, and centerless grinding. [2] A cylindrical grinder has a grinding (abrasive) wheel, two centers that hold the workpiece, and a chuck, grinding dog, or other mechanism to drive the work. Most ...

4. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   A reducer reduces the pipe size from a larger to a smaller bore (inner diameter). Alternatively, reducer may refer to any fitting which causes a change in pipe diameter. [15] This change may be intended to meet hydraulic flow requirements of the system or adapt to existing piping of a different size. The reduction length is usually equal to the ...

5. Tremie - Wikipedia

   en.wikipedia.org/wiki/Tremie

   Assembled tremie placing concrete underwater Hopper, pipes and lifting cap components of a tremie concrete placement tube. A tremie is a watertight pipe, usually of about 250 mm inside diameter (150 to 300 mm), [1] with a conical hopper at its upper end above the water level. It may have a loose plug or a valve at the bottom end.

6. Grinding wheel - Wikipedia

   en.wikipedia.org/wiki/Grinding_wheel

   Mainly grinding all kinds of metal, for the diameter of the inner wall of the grinding, mold correction. Rubber mounted points: finer particle size sand combined by rubber binder Into, for the polishing of the mold. sandpaper mounted points: Multi-piece rectangular sand cloth, bonding around the metal handle. Granularity is generally in the 60 ...

7. Tap and die - Wikipedia

   en.wikipedia.org/wiki/Tap_and_die

   where is the tap drill size, is the major diameter of the tap (e.g., 10 mm for a M10×1.5 tap), and pitch is the pitch of the thread (1.5 mm in the case of a standard M10 tap) and so the correct drill size is 8.5 mm. This works for both fine and coarse pitches, and also produces an approximate 75% thread.