When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Notching - Wikipedia

   en.wikipedia.org/wiki/Notching

   Notching is a metal-cutting process used on sheet-metal or thin bar-stock, sometimes on angle sections or tube. A shearing or punching process is used in a press, so as to cut vertically down and perpendicular to the surface, working from the edge of a work-piece.

3. Notch (engineering) - Wikipedia

   en.wikipedia.org/wiki/Notch_(engineering)

   The type of notch introduced to a specimen depends on the material and characterization employed. For standardized testing of fracture toughness by the Charpy impact method, specimen and notch dimensions are most often taken from American standard ASTM E23, or British standard BS EN ISO 148-1:2009.

4. Types of press tools - Wikipedia

   en.wikipedia.org/wiki/Types_of_press_tools

   Blanking is the operation of cutting flat shapes from sheet metal. The outer area of metal remaining after a blanking operation is generally discarded as waste. Size of blank or product is the size of the die & clearance is given on punch. It is a metal cutting operation. In blanking, metal obtained after cutting is not a scrap if it is usable.

5. Shear (sheet metal) - Wikipedia

   en.wikipedia.org/wiki/Shear_(sheet_metal)

   An alligator shear, historically known as a lever shear and sometimes as a crocodile shear, is a metal-cutting shear with a hinged jaw, powered by a flywheel or hydraulic cylinder. Alligator shears are generally set up as stand-alone shears; however, there are types for excavators. The jaw size can range from 4 to 36 in (100 to 910 mm) long.

6. Alligator shear - Wikipedia

   en.wikipedia.org/wiki/Alligator_shear

   An alligator shear, historically known as a lever shear [1] and sometimes as a crocodile shear, [2] is a metal-cutting shear with a hinged jaw, powered by a flywheel or hydraulic cylinder. Alligator shears are generally set up as stand-alone shears; however, there are types for excavators. The jaw size can range from 4 to 36 in (100 to 910 mm ...

7. Knockout punch - Wikipedia

   en.wikipedia.org/wiki/Knockout_punch

   In metalworking, a knockout punch, also known as a chassis punch, panel punch, Greenlee punch, or a Q-max, [1] is a hand tool used to punch a hole through sheet metal. It is a very simple tool that consists of a punch, die, and screw. There are three different drive systems: manual, ratchet, and hydraulic. [2]