Ads
related to: underground mining method
Search results
Results From The WOW.Com Content Network
Cut and fill mining is a method of short-hole mining used in steeply dipping or irregular ore zones, in particular where the hanging wall limits the use of long-hole methods. The ore is mined in horizontal or slightly inclined slices, and then filled with waste rock, sand or tailings. Either fill option may be cemented with binders to add ...
Underground soft-rock mining is a group of underground mining techniques used to extract coal, oil shale, potash, and other minerals or geological materials from sedimentary ("soft") rocks. [1] Because deposits in sedimentary rocks are commonly layered and relatively less hard , the mining methods used differ from those used to mine deposits in ...
Longwall mining is a form of underground coal mining where a long wall of coal is mined in a single slice (typically 0.6–6.0 m (2 ft 0 in – 19 ft 8 in) thick). The section of rock that is being mined, known as the longwall panel, is typically 3–4 km (1.9–2.5 mi) long, but can be up to 7.5 km (4.7 mi) long and 250–400 m (820–1,310 ft) wide.
Underground longwall mining. Mining techniques can be divided into two common excavation types: surface mining and sub-surface (underground) mining. Today, surface mining is much more common, and produces, for example, 85% of minerals (excluding petroleum and natural gas) in the United States, including 98% of metallic ores. [45]
Surface mining and deep underground mining are the two basic methods of mining. The choice of mining method depends primarily on depth, density, overburden, and thickness of the coal seam; seams relatively close to the surface, at depths less than approximately 55 m (180 ft), are usually surface mined. [citation needed]
Drift mining, mining horizontally; Shaft mining, mining vertically; Slope mining, mining at an inclined angle Stoping is the process of extracting out the ore from underground, leaving a hole called a stope; Room and pillar; Longwall mining; Retreat mining; Fire-setting, a method used in stoping by setting fires to timber and letting the ...
Room and pillar mining was one of the earliest methods used, [3] although with significantly more manpower. The room and pillar system is used in mining coal , gypsum , [ 4 ] iron , [ 5 ] limestone , [ 6 ] and uranium [ 7 ] ores, particularly when found as manto or blanket deposits, stone and aggregates , talc , soda ash , and potash . [ 8 ]
The primary underground mining method used was known as cut and fill. This involved mining the ceiling and using Ely Greenstone and other waste rock to artificially raise the floor at the same rate as the ceiling was being mined out. As a result, the floor and ceiling were always 10–20 feet (3–6 m) apart.