Ad
related to: capacitor impedance vs frequency calculator graph chart template
Search results
Results From The WOW.Com Content Network
The Smith chart (sometimes also called Smith diagram, Mizuhashi chart (水橋チャート), Mizuhashi–Smith chart (水橋スミスチャート), [1] [2] [3] Volpert–Smith chart (Диаграмма Вольперта—Смита) [4] [5] or Mizuhashi–Volpert–Smith chart), is a graphical calculator or nomogram designed for electrical and electronics engineers specializing in radio ...
The resonant frequency is defined as the frequency at which the impedance of the circuit is at a minimum. Equivalently, it can be defined as the frequency at which the impedance is purely real (that is, purely resistive). This occurs because the impedances of the inductor and capacitor at resonant are equal but of opposite sign and cancel out.
A resistor–capacitor circuit (RC circuit), or RC filter or RC network, is an electric circuit composed of resistors and capacitors. It may be driven by a voltage or current source and these will produce different responses. A first order RC circuit is composed of one resistor and one capacitor and is the simplest type of RC circuit.
In electrical engineering, impedance is the opposition to alternating current presented by the combined effect of resistance and reactance in a circuit. [1]Quantitatively, the impedance of a two-terminal circuit element is the ratio of the complex representation of the sinusoidal voltage between its terminals, to the complex representation of the current flowing through it. [2]
The reactance and impedance of a capacitor are respectively = = = = = where j is the imaginary unit and ω is the angular frequency of the sinusoidal signal. The − j phase indicates that the AC voltage V = ZI lags the AC current by 90°: the positive current phase corresponds to increasing voltage as the capacitor charges; zero current ...
Here the capacitance of capacitor C1 is multiplied by approximately the transistor's current gain (β). Without Q, R2 would be the load on the capacitor. With Q in place, the loading imposed upon C1 is simply the load current reduced by a factor of (β + 1). Consequently, C1 appears multiplied by a factor of (β + 1) when viewed by the load.
The self-resonant frequency is the lowest frequency at which the impedance passes through a minimum. For any AC application the self-resonant frequency is the highest frequency at which capacitors can be used as a capacitive component. This is critically important for decoupling high-speed logic circuits from the power supply.
The simplest switched-capacitor (SC) circuit is made of one capacitor and two switches S 1 and S 2 which alternatively connect the capacitor to either in or out at a switching frequency of . Recall that Ohm's law can express the relationship between voltage, current, and resistance as: =.